Motorola CLP1040 Charging the Battery, Estimated Charging Time, Charging a Standalone Battery

Page 21

Charging the Battery

To charge the battery (with the radio attached):

1.Place it in a Motorola-approved Drop-in Tray Single Unit Charger or Drop-in Tray Multi Unit Charger.

Note: When acquiring additional chargers or power supplies, make sure you have similar drop-in tray chargers and power supplies sets. For part number details, refer to “Chargers” Section on page 41.

Estimated Charging Time

The following table provides the estimated charging time of the battery.

Estimated Charging Time

Charging	Battery Type
Charging
Solution	Standard Li- Ion	High Capacity
	Battery	Li-Ion Battery
Standard
Charging	2.5 hours	3.5 hours
Solution

For further details, see “Batteries” Section on page 41.

Charging a Standalone Battery

To charge only the battery:

1.Insert the battery into the tray, with the inside surface of the battery facing the front of the charger, as shown.

2.Ensure the slots in the battery correctly engage in the charger.

BATTERY AND CHARGER FEATURES

13

Image 21

Contents Page Disclaimer Document CopyrightsContents Radio Frequency Code Charts Motorola Limited Warranty Batteries and Chargers Safety InformationProgramming the Radio Through CPS Radio CloningComputer Software Copyrights Product Safety and RF Exposure Compliance Radio Frequency RF Exposure Safety StandardsFCC Licensing Information FCC Licensing Information Introduction Radio Overview Getting Started Install the Battery Connecting an Audio Accessory Adjusting the Volume Installing and Removing the Swivel Belt Clip HolsterTurning the Radio On and Off Talk Range Transmitting and ReceivingHOW to Step Operation with Menu SettingsSelecting a Channel Default Channel Settings for CPSMonitoring a Channel Sending Call Tone enabled through CPSFor CLP1010 single-channel models For CLP1040 multi-channel modelsBattery Features Battery and Charger FeaturesAbout the Li-Ion Battery Battery LifeBattery Recycling and Disposal Power Supply, Adapter and Drop-in Tray Charger Removing the Lithium-Ion Li-Ion BatteryCharging the Battery Charging a Standalone BatteryEstimated Charging Time Charging with the Drop-in Tray Single Unit Charger SUC Charging Status LEDs Charger LED IndicatorLED Checking Battery StatusBatteries Chargers Safety Information Operational Safety Guidelines Radio Programming Overview Programming the Radio Through CPSDownloading the Customer Programming Software CPS Programming the RadioFactory Default Settings Cloning Radio Settings Radio CloningCloning Instructions Radio Cloning What to do if cloning fails Cloning the Radio through a Multi-Unit Charger Programming the RPX through a Single Unit Charger CLP Repeater Capability Working with RPXProgramming the RPX through a Multi-Unit Charger CLP Repeater Capability Working with RPXSymptom Try this TroubleshootingCan either reduce obstructions or increase power 13 and Charger LED Indicator Section on Cannot activate VOX VOX feature might be OFF If the portable is submerged in water USE and CareCLP UHF Frequencies Radio Frequency and Code ChartsRadiofrequency CCTSS/DPL Interference Eliminator Codes DPL Motorola Limited Warranty for the United States What Does this Warranty Cover?Products and Accessories Exclusions HOW to Obtain Warranty Service or Other INFORMATION? What WE will do to Correct Warranty ProblemsSoftware WHO is COVERED?Retain Your Original Proof of Purchase Software Copyright NoticeExport LAW Assurances Patent NoticeCarry Accessories AccessoriesBatteries ChargersAccessories Page 68012000044