Motorola CLP1040, CLP series, CLP1010 manual CLP Repeater Capability Working with RPX

Page 33

CLP REPEATER CAPABILITY: WORKING WITH RPX

CLP REPEATER CAPABILITY

Use the Single Unit Charger or use the pocket with “PROG” label on the Multi-Unit Charger to clone the RPX.

Note: Connect the RDX Serial Clone Cable (P/N RLN6303) and the Mini-USB to the Micro-USB Adapter Cable (P/N SKN6252) in order to link the CLP and RPX units.

INSTRUCTIONS

1.To put the CLP radio into clone mode, press and hold PTT and the “-” button while turning the radio ON until you hear the Cloning Tone

and Blinking Orange on the Smart Status Glow.

Programming the RPX through a

Single Unit Charger

		WORKINGWITHRPX	CLP
	Programming the RPX through a Single Unit	WORKINGWITHRPX	REPEATERCAPABILITY:
	Programming the RPX through a Single Unit
	Charger
1.	Place the CLP radio into the charging
	pocket.
2.	Connect the micro-USB plug of the micro-
	USB adapter cable with the RDX Serial
	Clone Cable into the micro-USB receptable
	charging pockets.
3.	Connect the Mini-USB plug of the RDX
	Serial Clone Cable into the RPX Mini-USB
	receptable.

25

Image 33

Contents Page Disclaimer Document CopyrightsContents Radio Frequency Code Charts Motorola Limited Warranty Batteries and Chargers Safety InformationProgramming the Radio Through CPS Radio CloningComputer Software Copyrights Product Safety and RF Exposure Compliance Radio Frequency RF Exposure Safety StandardsFCC Licensing Information FCC Licensing Information Introduction Radio Overview Getting Started Install the Battery Connecting an Audio Accessory Adjusting the Volume Installing and Removing the Swivel Belt Clip HolsterTurning the Radio On and Off Talk Range Transmitting and ReceivingHOW to Step Operation with Menu SettingsSelecting a Channel Default Channel Settings for CPSMonitoring a Channel Sending Call Tone enabled through CPSFor CLP1010 single-channel models For CLP1040 multi-channel modelsBattery Features Battery and Charger FeaturesAbout the Li-Ion Battery Battery LifeBattery Recycling and Disposal Power Supply, Adapter and Drop-in Tray Charger Removing the Lithium-Ion Li-Ion BatteryCharging the Battery Charging a Standalone BatteryEstimated Charging Time Charging with the Drop-in Tray Single Unit Charger SUC Charging Status LEDs Charger LED IndicatorLED Checking Battery StatusBatteries Chargers Safety Information Operational Safety Guidelines Radio Programming Overview Programming the Radio Through CPSDownloading the Customer Programming Software CPS Programming the RadioFactory Default Settings Cloning Radio Settings Radio CloningCloning Instructions Radio Cloning What to do if cloning fails Cloning the Radio through a Multi-Unit Charger Programming the RPX through a Single Unit Charger CLP Repeater Capability Working with RPXProgramming the RPX through a Multi-Unit Charger CLP Repeater Capability Working with RPXSymptom Try this TroubleshootingCan either reduce obstructions or increase power 13 and Charger LED Indicator Section on Cannot activate VOX VOX feature might be OFF If the portable is submerged in water USE and CareCLP UHF Frequencies Radio Frequency and Code ChartsRadiofrequency CCTSS/DPL Interference Eliminator Codes DPL Motorola Limited Warranty for the United States What Does this Warranty Cover?Products and Accessories Exclusions HOW to Obtain Warranty Service or Other INFORMATION? What WE will do to Correct Warranty ProblemsSoftware WHO is COVERED?Retain Your Original Proof of Purchase Software Copyright NoticeExport LAW Assurances Patent NoticeCarry Accessories AccessoriesBatteries ChargersAccessories Page 68012000044