Motorola CLP1040, CLP series, CLP1010 manual Radio Cloning

Page 30

RADIO CLONING

2.Plug one side of the cloning cable microconnector to one Single Unit Charger. Plug the other end to the second Single Unit Charger.

Note: During the cloning process no power is being applied to the Single Unit Charger. The batteries will not be charged. A data communication is being established between the two radios.

3.Turn ON the “Target Radio” and place it into one of the Single Unit Chargers.

4.On the “Source Radio”, power the radio following the sequence below:• Press and hold the Push-to-Talk (PTT) and the “-“Button simultaneously while turning the radio ON until you hear the Cloning Tone and Double

Blinking Orange on the Smart Status Glow.

5.Place the “Source Radio” in its Single Unit Charger with an Audio accessory, then press and release Menu Button to start the cloning process.

6.After cloning is completed, the “Source Radio” will sound either a “pass” tone (cloning was successful) or a “fail” tone (cloning process has failed). The pass tone sounds like a good key “chirp” whereas the “fail” tone sounds similar to a “bonk” tone. (A tone will be heard in no more than 5 seconds).

7.Once you have completed the cloning process, you should turn the radios “OFF” and “ON” to bring them to normal user mode (exit “clone” mode).

22

Image 30

Contents Page Document Copyrights DisclaimerContents Programming the Radio Through CPS Batteries and Chargers Safety InformationRadio Frequency Code Charts Motorola Limited Warranty Radio CloningComputer Software Copyrights Radio Frequency RF Exposure Safety Standards Product Safety and RF Exposure ComplianceFCC Licensing Information FCC Licensing Information Introduction Radio Overview Getting Started Install the Battery Connecting an Audio Accessory Adjusting the Volume Installing and Removing the Swivel Belt Clip HolsterTurning the Radio On and Off Transmitting and Receiving Talk RangeOperation with Menu Settings HOW to StepDefault Channel Settings for CPS Selecting a ChannelFor CLP1010 single-channel models Sending Call Tone enabled through CPSMonitoring a Channel For CLP1040 multi-channel modelsAbout the Li-Ion Battery Battery and Charger FeaturesBattery Features Battery LifeBattery Recycling and Disposal Removing the Lithium-Ion Li-Ion Battery Power Supply, Adapter and Drop-in Tray ChargerCharging the Battery Charging a Standalone BatteryEstimated Charging Time Charging with the Drop-in Tray Single Unit Charger SUC Charger LED Indicator Charging Status LEDsChecking Battery Status LEDBatteries Chargers Safety Information Operational Safety Guidelines Downloading the Customer Programming Software CPS Programming the Radio Through CPSRadio Programming Overview Programming the RadioFactory Default Settings Cloning Radio Settings Radio CloningCloning Instructions Radio Cloning What to do if cloning fails Cloning the Radio through a Multi-Unit Charger CLP Repeater Capability Working with RPX Programming the RPX through a Single Unit ChargerCLP Repeater Capability Working with RPX Programming the RPX through a Multi-Unit ChargerTroubleshooting Symptom Try thisCan either reduce obstructions or increase power 13 and Charger LED Indicator Section on Cannot activate VOX VOX feature might be OFF USE and Care If the portable is submerged in waterRadio Frequency and Code Charts CLP UHF FrequenciesRadiofrequency CCTSS/DPL Interference Eliminator Codes DPL Motorola Limited Warranty for the United States What Does this Warranty Cover?Products and Accessories Exclusions Software What WE will do to Correct Warranty ProblemsHOW to Obtain Warranty Service or Other INFORMATION? WHO is COVERED?Software Copyright Notice Retain Your Original Proof of PurchasePatent Notice Export LAW AssurancesBatteries AccessoriesCarry Accessories ChargersAccessories Page 68012000044