Nortel Networks P0886634 manual Re-installing the BIC in a new NAM

Page 29

Installing the DFC on systems equipped with a BIC 23

Figure 17 Re-installing the BIC in a new NAM

Slot 4

BIC

5.Push the BIC straight back until it fits snugly in place. Ensure the edge connector is firmly inserted into the socket.

6.If you have a NAM II, reconnect the Serial Port A and Serial Port B connectors to the SBC. Reconnect the keyboard/mouse connector to the SBC. For the location of the connectors, refer to Figure 13 on page 19.

Note: Ensure the keyboard/mouse ribbon cable is still connected to the backplane.

7.Fasten the slot cover screw in the BIC slot cover.

8.Replace the front cover.

P0886634 Issue 1.0

FAX Installation Guide

Image 29

Contents Norstar Voice Mail 4.0 FAX Installation Guide Page Contents FAX Installation Guide Regulatory information Repair facilities FAX overview Introduction to Norstar Voice Mail FAXFAX overview Special tools DFC overviewSpeciﬁcations Enabling the FAX software PrecautionsDVCs Shutting down the Norstar Voice Mail system Installation overviewUnlocking the module door Opening the NAMInstalling the DFC in the NAM Locating the expansion bus slots on a NAM Switch SW1 should be set according to the following table NAM PEB Cable installation example Installing the PEB CableDigital Voice Card Installing the PEB Cable Adding a Digital Voice Card after FAX is installed Installing the DFC on systems equipped with DVCs P0886634 Issue BIC Removing the BIC Keyboard/mouse backplane connector JP1 JP2 BIC connection points Re-installing the BIC in a NAM Re-installing the BIC in the NAMRe-installing the BIC in a new NAM Connecting the DFC to the BIC with the PEB Cable Connecting the BIC to the DFC in a NAM To connect the BIC to the DFC with the PEB cable Enabling the FAX software P0886634 Issue USA Comments Optional Your name Fax Company Norstar is a trademark of Northern Telecom. P0886634 Issue