NEC R1000 manual Restrictions, General Xen IPK Expanded

Xen IPK

September 2003

Doc. No. 8283 - Release 1.0

Features and Specifications for Xen IPK

Use Memory Block 3-72 (ISDN BRT Connection Configuration) to assign the BRT Interface as Point to Point or Point to Multipoint (default: Point to Multipoint).

Use Memory Block 4-47 (ISDN Directory Number Selection) to specify whether or not the directory number is presented to the network.

Use Memory Block 4-62 (ISDN DID Directory Number Assignment) to specify per station the outgoing Caller ID Number to be presented.

Use Memory Block 7-1 (Card Interface Slot Assignment) to specify the BRT(4)-U( ) ETU.

Restrictions

The ISDN-BRI interface provides a voice communication path only.

The System does not support Multipoint access.

General

Xen IPK Expanded

Eight BRT(4)-U( ) ETUs can be installed in a system.

Sixty-four ISDN trunks (B channels) can be assigned in a system.

The BRT(4)-U( ) ETU can be installed in any slot (1~8) of any cabinet (1~3).

Xen IPK Basic

Two BRT(4)-U( ) ETUs can be installed in a system.

Sixteen ISDN trunks (B channels) can be assigned in a system.

The BRT(4)-U( ) ETU can be installed in any slot (1~8) of any cabinet (1~3).

Common

ISDN Trunk DTMF Duration/Interdigit Selection is effective after Answer Supervision is received from the CO.

When an ISDN line Layer 1 or Layer 2 down condition occurs, the CO line key LED turns solid red, and the following message is displayed on the first line of the LCD of the Multiline Terminals connected to Port 01:

Layer 1 Down: COXX Layer1 DOWN

Layer 2 Down: COXX Layer2 DOWN

XX represents the CO Trunk number (01~64).

Layer 1 down display has a higher priority than Layer 2 down. This error display disappears automatically when Layer 1/Layer 2 error is recovered.

The Xen IPK system supports BRI ISDN lines conforming to the ETSI standard.

The BRT(4)-U( ) ETU supports the T-interface, but not the U- interface.