Binatone SC2050 manual Installation and set-up

Page 10

Battery Safety

-Cordless handset

ONLY use the rechargeable battery pack supplied with the cordless handset.

DO NOT use non-rechargeable batteries - they may burst and cause damage to your telephone.

CAUTION: Risk of explosion if replaced by an incorrect battery type. Dispose of used batteries according to the instructions.

Use only with Ni-MH AAA size 2.4V 500mAh rechargeable battery pack.

Installation and set-up

1Choose a suitable location for the base telephone See page 7

2 Connect the mains power lead and the telephone line cord into the base unit

3Plug the mains power adapter into a

Use only the telephone line cord supplied with your Big Button Combo

-do not use any other telephone line cord.

230 V AC, 50 Hz mains socket, with the switch on the socket set to OFF

4 Connect the base

telephone to the telephone line Insert the telephone line plug into the socket as shown.

NOTE: the charger pod does not have a connection to the telephone line.

9

Image 10

Contents User Guide If you need help Where to find it the cordless handset Where to find it the base telephone Contents Contents Whatthesymbolsmean HandsetRead these notes first If you have a Broadband linePage Installation and set-up Installation and set-up Charge light comes on Making and answering calls Press the Volume +/- buttons Press the Volume +/- buttons to set your desired ring melodyMemory dialling To make aSpeakerphone Your ear When the handset ringsHandset’s On and off but you must press the TalkLast Number Redial To mute the mouthpiece To lock the keypad Earpiece volume Ringer volume Ringer melody Telephone Telephone to CordlessButton until you hear a beep and a Display shows HS-. Within the 5 secondsNumber, e.g for Handset When the cordless handset is idle, pressTo page the cordless Handset » An intercom callGoes back to standby mode. The number is now stored Memory dialling Caller Display To return a » Display ‘beep’ RecordMulti-handset use Multi-handset use To shuttle Between two‘Intercom’ symbols are steady on your display Conference calls New Call toneDisplay then shows PIN Registering new handsetsLight flashes then release the button 0000To remove To idle modeYou may need to remove a cordless handset Self you want to removeTroubleshooting Move the cordless handset closer to the base telephoneTroubleshooting Troubleshooting Troubleshooting If the fault persists Guarantee and service Page Page Memory Dialling list Name