Binatone SC2050 manual Charge light comes on

Page 12

Installation and set-up

5 Charge the battery pack for 15 hours before you use the cordless handset

Before you use the handset for the first time, it is important that you charge the batteries fully. You will hear a ‘beep’ when the handset is correctly positioned on the charging cradle.

Leave the handset on the charger pod for 15 hours. To keep the batteries charged, whenever you don’t need to use the cordless handset (such as overnight, or when you go out), leave it on the charger pod.

The CHARGE light comes on

Note:

Battery life depends on device usage. Therefore, it is recommended that you read the following.

lWhen the batteries are low, the cordless handset will display the corresponding icon . Place the handset back on the charger pod: the battery icon will start scrolling.

lUse only original batteries and charge them only on the charger pod.

lInsert the battery pack properly as previously described.

lDo not dispose of the batteries in fire: this may cause an explosion.

lDo not expose the batteries to temperatures lower than -20 °C or higher than 60 °C; charge and use the batteries only in locations where the temperature is between 0 °C and 40 °C.

lRemove the battery pack from the compartment if the cordless handset is not used for a long period of time.

Binatone Help Line: 0845 345 9677 11

Image 12
Contents User Guide If you need help Where to find it the cordless handset Where to find it the base telephone Contents Contents Whatthesymbolsmean HandsetRead these notes first If you have a Broadband linePage Installation and set-up Installation and set-up Charge light comes on Making and answering calls Press the Volume +/- buttons Press the Volume +/- buttons to set your desired ring melodyMemory dialling To make aWhen the handset rings Handset’sSpeakerphone Your ear On and off but you must press the TalkLast Number Redial To mute the mouthpiece To lock the keypad Earpiece volume Ringer volume Ringer melody Telephone to Cordless Button until you hear a beep and aTelephone Display shows HS-. Within the 5 secondsWhen the cordless handset is idle, press To page the cordless Handset »Number, e.g for Handset An intercom callGoes back to standby mode. The number is now stored Memory dialling Caller Display To return a » Display ‘beep’ RecordMulti-handset use Multi-handset use To shuttle Between two‘Intercom’ symbols are steady on your display Conference calls New Call toneRegistering new handsets Light flashes then release the buttonDisplay then shows PIN 0000To idle mode You may need to remove a cordless handsetTo remove Self you want to removeTroubleshooting Move the cordless handset closer to the base telephoneTroubleshooting Troubleshooting Troubleshooting If the fault persists Guarantee and service Page Page Memory Dialling list Name