Binatone SC2050 manual Earpiece volume Ringer volume Ringer melody

Page 18

CORDLESS HANDSET

Earpiece volume

1

2

Ringer volume

1

2

3

Ringer melody

1

2

3

Making and answering calls

During a call, to adjust the volume in the cordless handset’s earpiece or speakerphone:

Press the VOLUME button

èThe display shows the current volume level (1 to 5 ) as a number of small circles

Press the VOLUME button repeatedly to cycle through the volume levels

(1, 2, 3, 4, 5, 1, 2, etc.)

èThe cordless handset will stay at this volume level until you change the volume again.

You have a choice of five ringing volume levels, or you can turn the ringer off altogether.

While the handset is idle (not busy on a call):

Press the VOLUME button briefly

èThe display shows the current volume level (Off, 1 to 5 ) as a number of small circles, and the handset rings at that level.

Press the RIGHT or LEFT button briefly to change the volume

Press the VOLUME button again to confirm

You have a choice of nine ringing melodies.

While the handset is idle (not busy on a call):

Press the VOLUME button and hold it for about 3 seconds

èThe display shows the current ringer (1 to 9 )

Press the RIGHT or LEFT button briefly to hear the different ringer melodies

When you reach the melody you prefer:

Press the VOLUME button again to confirm

Binatone Help Line: 0845 345 9677 17

Image 18

Contents User Guide If you need help Where to find it the cordless handset Where to find it the base telephone Contents Contents Whatthesymbolsmean HandsetRead these notes first If you have a Broadband linePage Installation and set-up Installation and set-up Charge light comes on Making and answering calls Press the Volume +/- buttons Press the Volume +/- buttons to set your desired ring melodyMemory dialling To make aSpeakerphone Your ear When the handset ringsHandset’s On and off but you must press the TalkLast Number Redial To mute the mouthpiece To lock the keypad Earpiece volume Ringer volume Ringer melody Telephone Telephone to CordlessButton until you hear a beep and a Display shows HS-. Within the 5 secondsNumber, e.g for Handset When the cordless handset is idle, pressTo page the cordless Handset » An intercom callGoes back to standby mode. The number is now stored Memory dialling Caller Display To return a » Display ‘beep’ RecordMulti-handset use Multi-handset use To shuttle Between two‘Intercom’ symbols are steady on your display Conference calls New Call toneDisplay then shows PIN Registering new handsetsLight flashes then release the button 0000To remove To idle modeYou may need to remove a cordless handset Self you want to removeTroubleshooting Move the cordless handset closer to the base telephoneTroubleshooting Troubleshooting Troubleshooting If the fault persists Guarantee and service Page Page Memory Dialling list Name