Binatone SC2050 manual Registering new handsets, Light flashes then release the button, 0000

Page 29

CORDLESS HANDSET

Registering new handsets

!If you have a Big Button Combo Twin, Triple, Quad or Quin system, all handsets are already registered to your base unit - the first as handset 1, the second as 2, etc.

You won’t need to re-register them unless you have a problem.

•The handset subscription has been removed from the base unit (e.g. for re-initialization).

•You want to subscribe a different handset to this base unit.

If you’ve bought extra handsets separately, you’ll need to register each one to your original base unit.

To register a 1

Press and hold the PAGE button on the base

handset

unit for about 10 seconds, until the IN USE

 

light flashes; then release the button

èYou now have 3 minutes to register the handset.

 

On the cordless handset:

2

Press and hold the CID/RIGHT button for 2

 

secs. until both the battery and the antenna

 

icon flashes

 

3

Press and hold the

button for 2 secs.

èThe display shows BS-

4

Key in a base unit number (1 to 4)

 

(If you have just one base unit, key in 1)

èThe display then shows PIN

5

Key in your handset’s PIN code (default

 

0000)

Your handset should now be registered. The display shows HS followed by the handset number.

Binatone Help Line: 0845 345 9677 28

Page 28 Page 30
Image 29
Page 28 Page 30
Contents User Guide If you need help Where to find it the cordless handset Where to find it the base telephone Contents Contents Handset WhatthesymbolsmeanIf you have a Broadband line Read these notes firstPage Installation and set-up Installation and set-up Charge light comes on Making and answering calls Press the Volume +/- buttons to set your desired ring melody Press the Volume +/- buttonsTo make a Memory diallingHandset’s When the handset ringsSpeakerphone Your ear On and off but you must press the TalkLast Number Redial To mute the mouthpiece To lock the keypad Earpiece volume Ringer volume Ringer melody Button until you hear a beep and a Telephone to CordlessTelephone Display shows HS-. Within the 5 secondsTo page the cordless Handset » When the cordless handset is idle, pressNumber, e.g for Handset An intercom callGoes back to standby mode. The number is now stored Memory dialling Caller Display Display ‘beep’ Record To return a »Multi-handset use Multi-handset use Between two To shuttleConference calls New Call tone ‘Intercom’ symbols are steady on your displayLight flashes then release the button Registering new handsetsDisplay then shows PIN 0000You may need to remove a cordless handset To idle modeTo remove Self you want to removeMove the cordless handset closer to the base telephone TroubleshootingTroubleshooting Troubleshooting Troubleshooting If the fault persists Guarantee and service Page Page Memory Dialling list Name
Top Page Image Contents