“The handset‘s batteries are running low within an hour or two.”
“The CHARGE light on the charger pod does not come on.“
“I try to recharge the batteries, but I still get a warning that they are low.”
“Last Number Redial and/or memory dialling don’t work.”
“My phone won’t work properly on a PBX”
Troubleshooting
Batteries
Before you first use the handset, you should have left it on the charger pod for up to 15 hours to charge the batteries fully. Repeat this.
You may need to replace the batteries. Contact the Binatone Help Line for advice.
Clean the battery charging contacts with a dry cloth. Check the connections between the base unit and the
mains power socket.
You need to replace the batteries. Please note these safety warnings:
n Use only NiMH (Nickel Metal Hydride) rechargeable batteries, as supplied with the handset.
n Dispose of used batteries safely - never burn them, or put them where they could get punctured.
Using your Big Button Combo on a PBX
When you first make a call, try pressing the 
button for a pause between the outside line access digit (e.g. 9) and the telephone number. You should later be able to redial the number.
When storing numbers in memory, you can include the outside line access digit (e.g. 9) with each number.
If your PBX requires you to wait for a second Dial tone
before dialling the telephone number, press the 
button for a pause between the access digit and the number.
You may need to change the recall setting. On the cordless
handset, press and hold the 
button, select ‘S’ for 100 ms or ‘L’ for 250 ms.
If in doubt, call the Help Line for advice. It will help if you have your PBX documentation to hand when you make the call.
Binatone Help Line: 0845 345 9677 33