Binatone SC2050 manual Last Number Redial To mute the mouthpiece To lock the keypad

Page 17

CORDLESS HANDSET

Last Number

Redial

1

2

3

or

To mute the mouthpiece

»

»

To lock the keypad

»

»

Making and answering calls

To make a repeat call to any one of the last three numbers you dialled:

Press the Last Number Redial/P button

èThe last number you dialled is shown on the display.

If necessary, press the Last Number Redial button again until the number you want is shown on the display

Press the TALK or SPEAKERPHONE button to dial the number

To put a call on hold, so that the person on the other end cannot hear you (but you will still be able to hear them):

Press the MUTE/DEL button once

èWhile the mouthpiece is muted, is shown on the display.

To get back to the call:

Press the MUTE/DEL button again

To lock the keypad so that no buttons can be pressed:

Press the LOCK button and hold it for about

3 seconds until the appears on the display

To unlock the keypad:

Press the LOCK button and hold it until the

disappears from the display

Binatone Help Line: 0845 345 9677 16

Image 17

Contents User Guide If you need help Where to find it the cordless handset Where to find it the base telephone Contents Contents Handset WhatthesymbolsmeanIf you have a Broadband line Read these notes firstPage Installation and set-up Installation and set-up Charge light comes on Making and answering calls Press the Volume +/- buttons to set your desired ring melody Press the Volume +/- buttonsTo make a Memory diallingHandset’s When the handset ringsSpeakerphone Your ear On and off but you must press the TalkLast Number Redial To mute the mouthpiece To lock the keypad Earpiece volume Ringer volume Ringer melody Button until you hear a beep and a Telephone to CordlessTelephone Display shows HS-. Within the 5 secondsTo page the cordless Handset » When the cordless handset is idle, pressNumber, e.g for Handset An intercom callGoes back to standby mode. The number is now stored Memory dialling Caller Display Display ‘beep’ Record To return a »Multi-handset use Multi-handset use Between two To shuttleConference calls New Call tone ‘Intercom’ symbols are steady on your displayLight flashes then release the button Registering new handsetsDisplay then shows PIN 0000You may need to remove a cordless handset To idle modeTo remove Self you want to removeMove the cordless handset closer to the base telephone TroubleshootingTroubleshooting Troubleshooting Troubleshooting If the fault persists Guarantee and service Page Page Memory Dialling list Name