AT&T 972 user manual Connect the power cord to the phone, Connect the handset to the telephone

972_00_1ATT BOOK 12/4/01 1:37 PM Page 9

INSTALLATION

5Connect the power cord to the phone.

Fit the power cord behind the strain relief tab. Then plug the smaller end of the power cord into the jack labeled POWER at the back of the system.

6Connect the line cord(s) to your modular jack(s) and mount the phone onto the wall.

•If you have a two-line jack, plug the free end of the line cord into the modular wall jack. Make sure the cord snaps firmly into place. Place the phone on the wall jack mounting studs and pull down until it is held securely.

•If you have two separate jacks, plug the free end of the cord with blue plugs into the modular wall jack for Line 1. Plug the free end of the cord with clear plugs into the modular wall jack for Line 2. Make sure the cords snap firmly into place. Place the phone on the mounting studs of one wall jack and pull down until it is held firmly in place.

7Connect the handset to the telephone.

Plug the coiled cord into the handset jack on the side of the phone. Plug the other end of the coiled cord into the handset, and then hang up.

8Plug the power cord into an AC outlet not controlled by a wall switch.

9Follow Steps 6 through 12 in “Table/Desk Installation.”

9