AT&T 972 user manual Table/Desk Installation, Base, Connect the line cords to the telephone

972_00_1ATT BOOK 12/4/01 1:36 PM Page 5

INSTALLATION

Table/Desk Installation

Note: Be sure to follow the steps below in order. Do not plug the phone into electrical power until all the cords are properly connected to the phone.

1The base.

Turn the base so the larger end is toward the top of the telephone. Attach the base by inserting the tabs into the slots. Push down on the large end of the base to lock it into place.

2Connect the line cord(s) to the telephone.

•If you have a two-line jack, use only a line cord with clear modular plugs on each end. Plug one end into the jack labeled L1 OR L1/2 on the back of the telephone.

•If you have two separate jacks, use two line cords. Insert one end of a cord with blue plugs into the jack labeled L1 OR L1/2 on the back of the telephone. Insert one end of the cord with clear plugs into the jack labeled L2 on the back of the telephone.

3Connect the line cord(s) to your modular jack(s).

•If you have a two-line jack, plug the free end of the line cord into a modular wall jack. Make sure the cord snaps firmly into place.

Two-line

Modular

Jack

Telephone Line Cord with clear modular plugs

AC

Adapter

Power Cord

5