972_00_1ATT BOOK 12/4/01 1:36 PM Page 4
INSTALLATION
Battery Installation
Before using the telephone, install a 9V battery (not included). In case of a power failure, you will be able to use the phone normally if a fresh 9V battery is installed, but Caller ID information will not be displayed. This phone has a Memory Loss protection feature and will store your caller ID information, memory and programmed settings until power is restored.
When battery power is low, LOW BATT shows on the display to alert you. Replace batteries promptly.
CAUTION: Always disconnect all cords and remove base before installing new batteries.
1Remove the label covering the display screen.
2Turn the telephone upside down.
3Remove the base (Figure 1).
Place your thumbs in the two openings at the large end of the base. Push down with your thumbs, and lift the base up and away from the phone.
4Open the battery compartment door (Figure 2). Press on the tabs and remove the door.
5Install one new 9V battery (Figure 3).
6Replace the battery compartment door.
7Turn to Step 1 in “Table/Desk Installation” or “Wall Installation”.
Figure 2
Figure 1 | Figure 3 |
4