AT&T 7406 manual Or Dial AD Program code Dial tone

To place an AD call	1	Press selected [ AD xxxxx ]
		● Press [ Select ] first if the [
		on a 2-level button
	2	Call is dialed (silently)

[ringback tone]

AD xxxxx ] is top-labeled

To program/reprogram an outside number, extension, or feature code into a personal list

1On a separate sheet of paper, jot down the outside numbers, extensions, and/or feature codes you want to program as items on your personal lists(s) (see example to the left)

Note: Each phone number or feature code is stored as a separate item.

2 Pick up handset [dial tone]

Note: If you are using the speakerphone, you must press a call appearance button before you begin Step 3.

3Press [ Program ]

or Dial AD Program code [dial tone]

4Dial Personal List number (1, 2, or 3)

[dial tone]

5 Dial list item (1, 2, 3...) [dial tone]

6Dial number you want to store (up to 24 digits)

Note: If you are programming an outside number, be sure to include a trunk code, if applicable.

7 Press [ # ] [confirmation tone]

●Repeat Steps 5–7 if you want to program additional items on the same list; press [ Drop Test ] and begin again at Step 1 if you want to program items on another list.

8Hang up or press [ Drop Test ] to end programming

Note: Record your personal list items on the Abbreviated Dialing list in the back of this booklet; group, system, and enhanced lists can be obtained from your System Manager.

12