Furuno FS-1562-25, FS-1562-15 manual Specifications of MF/HF Radiotelephone model FS-1562, General

Page 7

Specifications of MF/HF Radiotelephone model FS-1562

The model FS-1562-15/25 complies with the following rules and regulations:

-IMO A.421(XI), A.610(15), A613(15), A.694(17)

-International Convention on Safety of Life at Sea 1974, as amended 1988 (GMDSS Conference)

-ITU Radio Regulations

-ETS 300 373

-IEC 1097-9 draft, IEC 945 General Requirements

-EC EMC Directive for CE marking requirements

-Other relevant rules

GENERAL

Communication System	Simplex or semi-duplex
Frequency Range	1.6 to 27.5 MHz (transmit), 0.1 to 30 MHz (receive)
Frequency Resolution	Transmit: 100 Hz		Receive: 10 Hz
Class of Emission	J3E	SSB, suppressed carrier, signal channel containing analogue information, telephony;
		when 2182 kHz is first selected, H3E is set.
	H3E	SSB, full carrier, signal channel containing analogue information.
	J2B	for DSC, NBDP; SSB, suppressed carrier, signal channel containing quantized
		or digital information with the use of a modulating sub-carrier, telegraphy for
		automatic reception
	F3C	weather facsimile, reception only
Frequency Error	±10 Hz (Both Transmitter and Receiver)
Number of Channels	Custom channels: 200 max programmed by Furuno authorized service representatives
	ITU SSB/TELEX Channels as listed in Appendix
	2182 kHz (single action)
	2187.5 kHz (automatically selected on DSC equipment)
Environmental	IEC 945: -15°C to +55°C Transceiver unit, -25°C to +70°C ACU; 93% at 40°C
Power Supply	24 VDC +30%, -10%. For AC, a rectifier unit required.
	Receive:		2 A
	Transmit (max.):		FS-1562-15...20 A
			FS-1562-25...40 A
Radiotelephone Signal Generator		Two tones of 2200Hz and 1300Hz transmitted alternately.

TRANSMITTER

Output Impedance	50 ohms
Output Power	J3E/H3E:	FS-1562-15...150 W pep,	FS-1562-25...250 W pep
	J2B:	FS-1562-15...150 W pep,	FS-1562-25...250 W pep
		(FEC mode: reduced to 60 W)
	Tune: 10 to 20 W approx.
Power Reduction	60 W
Controls	Output HI/LOW, test

ANTENNA COUPLER

Power Capability	AT-1560-15...150 W pep
	AT-1560-25...250 W pep
Tuning System	CPU controlled fully automatic tuning system

v

Image 7

Contents Page T 9 9 Safety Instructions Do not disassemble or modify the equipment List of Contents Introduction FeaturesGeneral Specifications of MF/HF Radiotelephone model FS-1562Receiver Operation Rotary controls Front View of Transceiver UnitKeys Page AC and DC power switches Power Supply UnitFuses Selecting Frequency Starting operationYES TX Freq Standard type Netherlands type Special typeJ3E Direct frequency entryITU telephony channels SSB Custom channelsITU Telex channels Transmitting Tuning the antennaUsing the handset Monitoring transceiver output powerDistress Call on 2182 kHz Reducing transmitter powerDistress calls and Distress message Distress frequenciesDSC Distress Calling Event of Antenna Coupler FailureReceiving Channel scan Frequency ScanSquelch control Noise blanker NBITU channels Frequency SweepTelex Communication Optional DevicesRemote Station IntercomSetting Page Page This page is intentionally left blank Testing the transmitter with a dummy antenna Diagnostic TestWeekly Checks Page LCD/Keyboard Test & ROM Version No. Confirmation Competent technicians only Antenna Coupler TestMaintenance Page Troubleshooting List For qualified personnel only TroubleshootingTrouble Probable Cause Remedy Replacing Fuses Error IndicationThis page is intentionally left blank Appendix MF band working carrier frequencies ref. US CFR 47 Part CH no MF band SSB working carrier frequenciesFollowing frequencies are factory programmed MHz ITU SSB carrier frequencies ITU RR AppendixAP.5 12/16 MHz ITU SSB carrier frequencies ITU RR Appendix AP.7 MF Band Telex Frequency Table Telex ChannelsITU RR Appendix MHz Band ITU Nbdp Telex Frequency TableAP.10 AP.11 12/16 MHz Band ITU Nbdp Telex Frequency Table AP.13 18/19 MHz Band ITU Nbdp Telex Frequency Table AP.15 22, 25/26 MHz Band ITU Nbdp Telex Frequency Table