Furuno FS-1562-15, FS-1562-25 manual Front View of Transceiver Unit, Rotary controls, Keys

Page 10

1.2 Front View of Transceiver Unit

(Same for FS-1562-15 and FS-1562-25)
Loudspeaker		Operation Display						Keyboard
		SSB TRANSCEIVE FS-1562-15
								MODE	CURS CLARIFY
								1	2	3	TX
									SQ	SCAN
		SIMP			R			4	5	6	RX
		SIMP			R
		0	2	4	6	8	10 S	TX TUNE HI LOW
								TX TUNE HI LOW
							AGC NB	7	8	9	RCL
								H3E	INTERCOM	START
									INTERCOM	START
	MIC	VOLUME					RF GAIN	2182	0	ALARM	ENT
	MIC	VOLUME					RF GAIN	FREQ/CH	TEST		STOP
									TEST		STOP
		OFF							S/N:
									S/N:
Microphone	Volume control				RF GAIN			FREQ/CHANNEL	Xtal oven light
Hndset Jack	w/Power ON/OFF				control			selector	(LED)

Rotary controls

VOLUME		Turns the power on and off and adjust the loudspeaker volume.
		When FS-1562 is connected to DB-500 and RB-500, FS-1562 can be turned
		on by RB-500.
		This is possible with the RB-500 having ROM version 1.04 and after.
RF GAIN		Adjusts the receiver sensitivity.
FREQ/CH		Changes the frequency in conjunction with the [TX] or [RX] key. Also changes
		the channel numbers set with the [RCL] key.
Keys
[1]	(MODE)	Selects a class of emission and controls AGC on and off. Press the [1] key
		repeatedly until the wanted class of emission appears.
[2]	(CURSor)	Shifts cursor (underline marking). Press the [2] key to move the cursor.
[3]	(CLARIFY)	Adjusts the receiver frequency for fine tuning when the frequency is set in
		terms of Channel NO. Not active in direct frequency entry. The adjustable
		range is ±150 Hz in 10 Hz steps.
[TX]		Selects a TX frequency.
[4]	(speaker)	Turns the internal or external loudspeaker on or off. The speaker mark appears
		on the display when the speaker is off.

-1.2-

Image 10

Contents Page T 9 9 Safety Instructions Do not disassemble or modify the equipment List of Contents Features IntroductionSpecifications of MF/HF Radiotelephone model FS-1562 GeneralReceiver Operation Rotary controls Front View of Transceiver UnitKeys Page AC and DC power switches Power Supply UnitFuses Starting operation Selecting FrequencyTX Freq Standard type Netherlands type Special type YESDirect frequency entry J3ECustom channels ITU telephony channels SSBITU Telex channels Monitoring transceiver output power Tuning the antennaUsing the handset TransmittingReducing transmitter power Distress Call on 2182 kHzDistress frequencies Distress calls and Distress messageEvent of Antenna Coupler Failure DSC Distress CallingReceiving Noise blanker NB Frequency ScanSquelch control Channel scanFrequency Sweep ITU channelsOptional Devices Telex CommunicationIntercom Remote StationSetting Page Page This page is intentionally left blank Testing the transmitter with a dummy antenna Diagnostic TestWeekly Checks Page LCD/Keyboard Test & ROM Version No. Confirmation Antenna Coupler Test Competent technicians onlyMaintenance Page Troubleshooting Troubleshooting List For qualified personnel onlyTrouble Probable Cause Remedy Error Indication Replacing FusesThis page is intentionally left blank Appendix MF band working carrier frequencies ref. US CFR 47 Part MF band SSB working carrier frequencies CH noMHz ITU SSB carrier frequencies ITU RR Appendix Following frequencies are factory programmedAP.5 12/16 MHz ITU SSB carrier frequencies ITU RR Appendix AP.7 Telex Channels MF Band Telex Frequency TableMHz Band ITU Nbdp Telex Frequency Table ITU RR AppendixAP.10 AP.11 12/16 MHz Band ITU Nbdp Telex Frequency Table AP.13 18/19 MHz Band ITU Nbdp Telex Frequency Table AP.15 22, 25/26 MHz Band ITU Nbdp Telex Frequency Table