Furuno FS-1562-25, FS-1562-15 manual Setting

Page 27

Chapter 3 CHANGING SYSTEM

SETTING

3.1 SYSTEM SETUP

1.While pressing and holding down the [RCL] key, turn on the power. Release the [RCL] key when the “MEMO” appears on the display.

System code

Setting value

MEMO

2.Turn the FREQ/CH control to select a desired code number.

3.Press the [RCL] key, enter desired setting by a numeral key, then press the [ENT] key.

4.To change setting for another code, repeat steps 2 and 3.

5.Turn off the power, then turn it on.

3.2 CUSTOMIZING BY OPERATOR

The operator can customize the parameters for scan, sweep and squelch function. The table below shows the system codes and their function, setting range and factory setting.

Code

Function, Setting

9918

Key response

 

Turns on/off key beep which sounds when wrong key is operated.

 

0: OFF

 

1: ON (Factory Setting)

9919

Noise blanker activation

 

Turns on/off noise blanker.

 

0: OFF

 

1: ON (Factory Setting)

9920

AGC activation

 

Turns on/off AGC. ON/OFF automatically activates or deactivates AGC

 

depending on class of emission.

0: OFF

1: ON

2: MODE (Factory Setting)

-3.1-

Image 27
Contents Page T 9 9 Safety Instructions Do not disassemble or modify the equipment List of Contents Introduction FeaturesGeneral Specifications of MF/HF Radiotelephone model FS-1562Receiver Operation Front View of Transceiver Unit Rotary controlsKeys Page Power Supply Unit AC and DC power switchesFuses Selecting Frequency Starting operationYES TX Freq Standard type Netherlands type Special typeJ3E Direct frequency entryITU telephony channels SSB Custom channelsITU Telex channels Transmitting Tuning the antennaUsing the handset Monitoring transceiver output powerDistress Call on 2182 kHz Reducing transmitter powerDistress calls and Distress message Distress frequenciesDSC Distress Calling Event of Antenna Coupler FailureReceiving Channel scan Frequency ScanSquelch control Noise blanker NBITU channels Frequency SweepTelex Communication Optional DevicesRemote Station IntercomSetting Page Page This page is intentionally left blank Diagnostic Test Testing the transmitter with a dummy antennaWeekly Checks Page LCD/Keyboard Test & ROM Version No. Confirmation Competent technicians only Antenna Coupler TestMaintenance Page Troubleshooting List For qualified personnel only TroubleshootingTrouble Probable Cause Remedy Replacing Fuses Error IndicationThis page is intentionally left blank Appendix MF band working carrier frequencies ref. US CFR 47 Part CH no MF band SSB working carrier frequenciesFollowing frequencies are factory programmed MHz ITU SSB carrier frequencies ITU RR AppendixAP.5 12/16 MHz ITU SSB carrier frequencies ITU RR Appendix AP.7 MF Band Telex Frequency Table Telex ChannelsITU RR Appendix MHz Band ITU Nbdp Telex Frequency TableAP.10 AP.11 12/16 MHz Band ITU Nbdp Telex Frequency Table AP.13 18/19 MHz Band ITU Nbdp Telex Frequency Table AP.15 22, 25/26 MHz Band ITU Nbdp Telex Frequency Table