Bogen UTI312 specifications Override Input, 90V Night Ring Input

Page 10

Override Input

The Override is a feature that lets the caller take priority over all other paging functions and make a page.

The center two conductors interface directly to a Loop Start Trunk or a dedicated phone.When the trunk becomes active, the UTI312 goes into Override mode. A contact closure and dry audio source can also be used for the Override Input. The two conductors flanking the talk battery conductors provide a dry audio gateway into the system override. Override is activated by shorting the outermost conductors.

Maximum contact closure resistance is 1000 ohms. Open collector type outputs for controlling a page may also be used. The Override feature includes a quad beep pre-announce tone that can be enabled or disabled. (The default is enabled.) Make sure that the power is disconnected and all other connections are completed before proceeding. Plug modular cord into OVERRIDE (RJ11) jack.

90V Night Ring Input

The 90V Night Ring Input connects to an analog station line from the PBX or directly to a central office phone line. The UTI312 will follow the incoming ring signal cadence with a simulated ring or chime tone to the Night Ring zone group.

Note: The Night Ring feature has priority just above background music.There is a 5-second delay after the night ring stops before background music is restored (to bridge inter-ring pause).

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Installation and Use Manual UL Approved Contents Introduction Panel Descriptions UTI312 Front Panel with ZX3 Installed UTI312 CalloutsZX3 Callouts Wall Mounting InstallationRack Mounting, Recessed for Wire Access Rack Mounting, FlushTelephone System Connections Telephone Interface Wiring Connections & SetupPBX Analog Station Port PBX Loop Start Trunk Port PBX Ground Start Trunk PortPBX Page Port Contact Trunk DisconnectPBX Page Port VOX Override Input 90V Night Ring InputTone Trigger Inputs 1 Other ConnectionsNight Ringer Contact Background Music InputsZX3 Module Paging Output Connections ZX3 Power Supply OutputZX3 Module Connections ZX3 AUX ContactsControls Paging Zone Groups Features & OperationZones All-Call Zone GroupNight Ring Zone Group & Tone Auto Select Zone GroupOverride Zone Group & Tone Tone Trigger 1 & 2 Zone Groups & TonesFlexible Dialing Code Call Zone Group & TonesAUX Relay Contact Confirmation ToneReset Default Values TimersSetup Tone Dialing Time-outProgram. See the Feature Codes & Defaults charts System ProgrammingPattern Code Call Tone Zone GroupsCode Calling Echo Code CallEvent-Driven/Priority-Driven Mode Event Enable/DisableDelay/No Delay Example 2 Strobes Flash to Announce Night Ring Priority-Driven Mode IssuesExample 1 Emergency Tone/Emergency Announcement Bypass Example 3 Message Playback Following ToneFlexible Dialing Reference Chart Feature Codes & Defaults Trunk DisconnectFeature Code Data Default Renumber Zone Feature Code Test Mode Specifications Block Diagram, UTI312 Block Diagram, ZX3 Limited Warranty Page Spring Street, Ramsey, NJ 07446, U.S.A
Top Page Image Contents