Bogen specifications Block Diagram, UTI312

Page 28

28

Block Diagram, UTI312

* Ground points marked with an asterisk must not be connected to Earth Ground when GND ST terminal is connected to Earth Ground.

Image 28

Contents Installation and Use Manual UL Approved Contents Introduction Panel Descriptions UTI312 Front Panel with ZX3 Installed UTI312 CalloutsZX3 Callouts Installation Rack Mounting, Recessed for Wire AccessWall Mounting Rack Mounting, FlushTelephone System Connections Telephone Interface Wiring Connections & SetupPBX Analog Station Port PBX Loop Start Trunk Port PBX Ground Start Trunk PortPBX Page Port Contact Trunk DisconnectPBX Page Port VOX Override Input 90V Night Ring InputOther Connections Night Ringer ContactTone Trigger Inputs 1 Background Music InputsZX3 Power Supply Output ZX3 Module ConnectionsZX3 Module Paging Output Connections ZX3 AUX ContactsControls Features & Operation ZonesPaging Zone Groups All-Call Zone GroupAuto Select Zone Group Override Zone Group & ToneNight Ring Zone Group & Tone Tone Trigger 1 & 2 Zone Groups & TonesCode Call Zone Group & Tones AUX Relay ContactFlexible Dialing Confirmation ToneTimers Setup ToneReset Default Values Dialing Time-outProgram. See the Feature Codes & Defaults charts System ProgrammingTone Zone Groups Code CallingPattern Code Call Echo Code CallEvent-Driven/Priority-Driven Mode Event Enable/DisableDelay/No Delay Priority-Driven Mode Issues Example 1 Emergency Tone/Emergency Announcement BypassExample 2 Strobes Flash to Announce Night Ring Example 3 Message Playback Following ToneFlexible Dialing Reference Chart Feature Codes & Defaults Trunk DisconnectFeature Code Data Default Renumber Zone Feature Code Test Mode Specifications Block Diagram, UTI312 Block Diagram, ZX3 Limited Warranty Page Spring Street, Ramsey, NJ 07446, U.S.A