Features & Operation, Zones, Paging Zone Groups

Features & Operation

Zones

The UTI312 offers up to twelve zones of paging.These zones are numbered 01 through 12 by default and do not require any programming, though they may be renumbered using the Flexible Dialing feature.

To page to a zone:

1. Dial the paging access number for your telephone system.

2.Listen for the confirmation tone (if enabled).

3.Dial the zone number. Default zone numbers require 2 digits to be dialed. Zones renumbered using Flexible Dialing must be dialed as programmed.

4.Listen for pre-announce tone (if enabled).

5.Make the page and hang up when finished.

To renumber a zone, see Flexible Dialing on page 22. It is possible to page to a zone that does not exist. An error tone will be heard by the calling party when this occurs. A disconnection from the system will occur when paging to a zone that is not installed in Station mode and when in Trunk mode if the Trunk Disconnect feature is enabled.

Paging Zone Groups

Rather than page each zone separately, the UTI312 allows up to 24 paging zone groups to be programmed. These zone groups permit the user to program multiple paging zones into a single paging zone group.These zone groups are numbered *01 through *24 by default. These zone groups may be renumbered using Flexible Dialing. For information on programming and renumbering paging zone groups, refer to the System Programming section.

To page to a paging zone group:

1. Dial the paging access number for your telephone system.

2.Listen for the confirmation tone (if enabled).

3.Dial the * key followed by the paging zone group number if a default paging zone group number is being used. An * is not used when Flexible Dialing is enabled. Paging zone groups renumbered using Flexible Dialing must be dialed as programmed.

4.Listen for pre-announce tone (if enabled).

5.Make the page and hang up when finished.

It is possible to page to a zone group that is not installed.An error tone will be heard by the calling party when this occurs.A disconnection from the system will occur when paging to a zone that is not installed in Station mode and when in Trunk mode if the Trunk Disconnect feature is enabled.

All-Call Zone Group

By default, the All-Call zone group is programmed to include all zones. It is necessary to dial 00 to access All-Call. The All-Call zone group can be programmed to include specific zones like other zone groups and may be disabled. For information on programming or disabling All-Call, refer to the System Programming section.

To page to the All-Call zone group:

1. Dial the paging access number for your telephone system.

2.Listen for the confirmation tone (if enabled).

3.Dial 00.

4.Listen for pre-announce tone (if enabled).

5.Make the page and hang up when finished.