3Com 78-11069-01 manual Adding the DPA 7630 Manually

Page 4

Chapter 3 Preparing the Cisco CallManager and Octel Systems

Configuring Cisco CallManager

Cisco CallManager only recognizes these IP phones after the Octel voice mail system is up and running. So, verify that the Octel system and the Cisco DPA 7630 are up before completing these tasks in Cisco CallManager.

Auto-registration automatically assigns phones a directory number. The directory number assigned is the next one available in sequential order within the device pool assigned to this phone type in Cisco CallManager. However, if you need to, you can modify this directory number for each emulated phone (see the “Configuring the DPA Ports and Phones” section on page 3-5).

During auto registration, the host name assigned to the DPA 7630 is entered in the Description field in the record for the emulated phone in Cisco CallManager. If you do not enter a host name, the following sequence applies for the device description: SEP + the last 10 digits of the MAC address.

Additionally, Cisco CallManager requires unique MAC addresses for all devices, but all 24 ports on the DPA 7630 share the same MAC address. Therefore, an automatic conversion process converts the MAC addresses into this format:

1.The first two digits for the MAC address are dropped.

2.The number is shifted two places to the left.

3.The two-digit port number is added to the right.

For example, if the MAC address is

000039A44218

the MAC address registered for port 12 in CallManager is

0039A4421812

The 25th virtual port is automatically assigned the MAC address of 0039A4421825.

Adding the DPA 7630 Manually

If you want to assign specific directory numbers to the emulated IP phones on the DPA 7630 without using auto-registration, you must manually add each phone to the Cisco CallManager database. Keep in mind several important facts:

•Each port must have a unique MAC address. Use the auto-registration formula.

•Use the host name or other name for the Description for each port. Use the same name for ports configured on the same DPA 7630 system.

•Add each port on the DPA 7630 as a Cisco IP Phone 30 VIP.

 

Cisco Digital PBX Adapter 7630 Administration Guide

3-4

78-11069-01

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Preparing the Cisco CallManager and Octel Systems Overview of Required TasksConfiguring Cisco CallManager Task For More InformationUsing Auto-Registration Adding the DPA 7630 to Cisco CallManagerAdding the DPA 7630 Manually Configuring Call Ports Configuring the DPA Ports and PhonesOutgoing Calls Incoming Calls Configuring Octel MWI Ports Line Configuration for Voice Mail PortsConfiguring the Virtual Port Line Configuration for Octel MWI PortsConfiguring an End-User Phone Line Configuration for End-User PhoneCisco CallManager MWI OFF Setting Enabling the Message Waiting LightSetting Up the Voice Mail Hunt Group Cisco CallManager MWI on SettingConfiguring the Pilot Directory Number Setting the Hop CountConfiguring the Octel Systems Setting No-Answer TimeoutSetting Dialing Sequence for Message Waiting Indicator Assigning Incoming, Outgoing, and MWI Lines
Top Page Image Contents