3Com 78-11069-01 manual Enabling the Message Waiting Light, Cisco CallManager MWI OFF Setting

Page 10

Chapter 3 Preparing the Cisco CallManager and Octel Systems

Configuring Cisco CallManager

Enabling the Message Waiting Light

On Cisco CallManager, you must set the option to enable the message waiting light on Cisco IP Phones. Once configured, you can access the values used to enable and disable the message waiting light by following these procedures. These options appear under the Service > Service Parameters menu in Cisco CallManager. You must configure these settings for each

Cisco CallManager system in a cluster.

In these examples, the MessageWaitingOffDN value is 1998, and the MessageWaitingOnDN value is 1999. Record these values. You need them to configure the DPA 7630.

MessageWaitingOffDN—Specifies the directory number to which calls from a voice mail system are directed to disable or turn off the MWI light for the specified calling party (see Figure 3-4).

Figure 3-4 Cisco CallManager MWI OFF Setting

45698

 

Cisco Digital PBX Adapter 7630 Administration Guide

3-10

78-11069-01

Image 10
Contents Preparing the Cisco CallManager and Octel Systems Overview of Required TasksConfiguring Cisco CallManager Task For More InformationUsing Auto-Registration Adding the DPA 7630 to Cisco CallManagerAdding the DPA 7630 Manually Configuring Call Ports Configuring the DPA Ports and PhonesOutgoing Calls Incoming Calls Configuring Octel MWI Ports Line Configuration for Voice Mail PortsConfiguring the Virtual Port Line Configuration for Octel MWI PortsConfiguring an End-User Phone Line Configuration for End-User PhoneCisco CallManager MWI OFF Setting Enabling the Message Waiting LightSetting Up the Voice Mail Hunt Group Cisco CallManager MWI on SettingConfiguring the Pilot Directory Number Setting the Hop CountConfiguring the Octel Systems Setting No-Answer TimeoutSetting Dialing Sequence for Message Waiting Indicator Assigning Incoming, Outgoing, and MWI Lines