3Com 78-11069-01 manual Configuring Octel MWI Ports, Line Configuration for Voice Mail Ports

Page 7

Chapter 3 Preparing the Cisco CallManager and Octel Systems

Configuring Cisco CallManager

Figure 3-1 Line Configuration for Voice Mail Ports

Configuring Octel MWI Ports

The DPA 7630 uses the Octel MWI ports to handle MWI messages from the Octel system. You can also enable these lines to support outgoing call processing. However, you must not configure these ports to handle any incoming call processing. See Figure 3-2 for an example of the following settings:

•Directory Number—Assign a directory number to each of these phones. Ensure that these directory numbers are not included in the voice mail hunt group. For this example, use 1301.

•Call waiting—We recommend that you disable call waiting on these phones.

•Call forwarding—Do not set.

 

 

Cisco Digital PBX Adapter 7630 Administration Guide

 

 

 

 

 

 

78-11069-01

 

 

3-7

 

 

 

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Overview of Required Tasks Preparing the Cisco CallManager and Octel SystemsTask For More Information Configuring Cisco CallManagerAdding the DPA 7630 to Cisco CallManager Using Auto-RegistrationAdding the DPA 7630 Manually Configuring Call Ports Configuring the DPA Ports and PhonesOutgoing Calls Incoming Calls Line Configuration for Voice Mail Ports Configuring Octel MWI PortsLine Configuration for Octel MWI Ports Configuring the Virtual PortLine Configuration for End-User Phone Configuring an End-User PhoneEnabling the Message Waiting Light Cisco CallManager MWI OFF SettingCisco CallManager MWI on Setting Setting Up the Voice Mail Hunt GroupSetting the Hop Count Configuring the Pilot Directory NumberSetting No-Answer Timeout Configuring the Octel SystemsAssigning Incoming, Outgoing, and MWI Lines Setting Dialing Sequence for Message Waiting Indicator
Top Page Image Contents