Connecting the Speakers
Connect the satellite speakers, center speaker, and subwoofer to the terminals on the rear panel using speaker cords supplied.
Labels are attached to the speaker cords to indicate the terminals to be connected.
•Connect the red cord to the red (+) terminal, and the black cord to the black
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
Connecting speaker cords to the terminals
1 | 2 | 3 |
1Press and hold the terminal clamp.
2Insert the speaker cord.
3Release the finger from the clamp.
Notes:
• If the speaker cord is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.
• Make sure the core wire of speaker cords do not expose to out of the terminals. This could cause
When setting the speakers
To obtain the best possible sound from this system, you need to place all the speakers except the subwoofer at the same distance from the listening position with each front faced toward the listener. Since bass sound is
Left front Center speaker | Right front | ||
speaker |
|
| speaker |
|
| ||
|
|
|
|
Subwoofer
Left rear | Right rear |
speaker | speaker |
If your speakers cannot be placed at the same distance from the listening position
You can adjust the delay time of the center speaker and rear speakers. For
Note:
You can change the phase of subwoofer sounds by connecting the speaker cords to the terminals
CAUTION:
•When attaching the satellite speakers on the wall, have them attached to the wall by a qualified person.
DO NOT attach the satellite speakers on the wall by yourself to avoid an unexpected damage of their falling from the wall, caused by incorrect attachment or weakness in the wall.
•Care is required in selecting a location for attaching speakers to the wall. Injury to personnel, or damage to equipment, may result if the speakers are attached in a location which interferes with daily activities.
7
