JVC TH-A30R Creating Realistic Sound Fields, Press SOUND repeatedly until the, “Sw.”, activated

Creating Realistic Sound Fields

2 3

D.R.C

REW FF

VCR CHANNEL

TUNING

B.SEARCH F.SEARCH

ENTER

VOLUME

TOP MENU MENU RETURN MUTING

			SOUND
1	2	3
PTY –	PTY SEARCH	PTY +	SETTING
4	5	6
			PRO LOGIC
7	8	9
SLOW		SETUP	TEST

0

ANGLE ZOOM D.R.C DSP MODE

REPEAT A-B REPEAT PROGRAM

CLEAR SEARCH REMAIN SLEEP

SOUND

PRO LOGIC

DSP MODE

3To adjust the output balance for the front speakers

1) Press SOUND repeatedly until the	SOUND
adjustment indication for the front
speakers appears on the display.

•Each time you press the button, the adjustment indication on the display changes as follows:

00 F 00 00 R 00 CEN

Normal indication	SW	REAR
(canceled)

2) Press 3 or 2 to adjust the output balance.

3: Decreases the left speaker

output, or restores the right	ENTER
speaker output.
2 : Decreases the right speaker
output, or restores the left
speaker output.

Adjusting Stereo Sound

•The output balance changes from

OFF (silence), –06 (most reduction) to 00 (no reduction).

•“00 F 00” is the initial setting (the output balance is at the center position). If you have already changed the setting, another value will appear.

You can adjust the following settings.

It is recommended that you make adjustments from your actual listening point while listening to reproduced sounds.

–Output balance for the front speakers

–Output level for the subwoofer

Once you adjust these items, the adjustments take effect for all the surround modes.

4To adjust the output level for the subwoofer

1) Press SOUND repeatedly to select	SOUND
“SW.”

•Each time you press the button, the adjustment indication on the display changes as follows:

Before you start, remember...

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

00 F 00 00 R 00 CEN

Normal indication	SW	REAR
(canceled)

1Select and play any source except Dolby Digital or DTS Digital Surround.

2Cancel Dolby Surround or DSP modes if they are

activated.

For deactivating Dolby Surround:

PRO LOGIC

Press PRO LOGIC on the remote control until “STEREO” appears on the display.

For deactivating DSP modes: DSP MODE

Press DSP MODE (or DSP on the front panel) until the DSP indicator goes off from the display.

Now, you are ready to start adjustments.

•To adjust the output balance for the front speakers, go to the next step.

•To adjust the output level for the subwoofer, go to step 4.

2) Press 3 or 2 to adjust the output level.

3: Increases the output level.

2 : Decreases the output level.

• The output level changes from –6 to +6.

• “SW 0dB” is the initial setting. If you have already changed the settings, another value will appear.

ENTER

20