Connecting the FM and AM Antennas
If AM reception is poor, connect single
1 | 2 | 3 |
AM Loop Antenna (supplied)
If FM reception is poor, connect outdoor FM antenna (not supplied).
FM Antenna (supplied)
MIN | MIN | MIN | MIN |
Snap the tabs on the loop into the slots of the base to assemble the AM loop antenna.
Y/C
COMP.
Cooling fan
Center unit
(See “About the cooling fan” below.)
FM antenna connection
Connect the supplied FM antenna to the FM 75 Ω COAXIAL terminal as temporary measure.
Extend the supplied FM antenna horizontally.
•If reception is poor, connect an outdoor antenna. Before attaching a 75 Ω coaxial cable (with a standard type connector), disconnect
the supplied FM antenna.
AM antenna connection
Connect the supplied AM loop antenna to the AM and H terminals. Turn the loop until you have the best reception.
•If reception is poor, connect an outdoor single
Note:
If the AM loop antenna wire is covered with vinyl, remove
the vinyl by twisting it as shown in the diagram.
About the cooling fan
A cooling fan is mounted on the rear panel of the center unit to prevent abnormal temperature inside the center unit, thus assuring normal operation of the unit. The cooling fan automatically starts rotating to supply external cool air to the inside of the center unit when the internal temperature goes up.
For safety, observe the following carefully.
•Make sure there is good ventilation around the center unit. Poor ventilation could overheat and damage the center unit.
•DO NOT block the cooling fan and the ventilation openings or holes. (If they are blocked by a newspaper or cloth, etc., the heat may not be able to get out.)
•DO NOT touch the speaker cords to the cooling fan.
5
