Polycom Mitel Networks 3300, 72-1084-02, SX-200 ICP manual Dhcp, Configuration Note

SpectraLink Corporation	Configuration and Administration—NetLink e340/i640 Wireless Telephone
	Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
Message	Description	Action
Net Busy	x…x = AP MAC address	Try the call again later.
xxxxxxxxxxxx	Handset cannot obtain sufficient bandwidth
	to support a call; displays MAC of failing AP.
No DHCP Server	Handset is unable to contact the DHCP	Check that DNCP is operational and
	server.	connected to WLAN or use Static IP
		configuration in the handset.
No ESSID	Attempted to run site survey application	Let handset come completely up.
	without an ESSID set.	Statically configure an ESSID in the Admin
		menu.
No Func Code	Handset software download files are	Reconfigure the handset to gain access to
	incorrect or corrupted	the WLAN and download new code.
No Host IP	The handset is configured for “static IP” (as	Enter a valid IP address in the
	opposed to “use DHCP”) and no valid host IP	configuration settings or change to “use
	address (the handset’s IP address) has been	DHCP”.
	entered.
No IP Address	Invalid IP	Check the IP address of the handset and
		re-configure if required.
No Net Access	Cannot authenticate / associate with AP	Verify the AP configuration.
		Verify that all the WEP settings in the
		handset match those in the APs.
No Net Found	Handset cannot find any Access Points
No APs	This indicates any of the following:
	No radio link	Verify that the AP is turned on.
	No ESSID – Auto-learn not supported (or)	Verify the ESSID of the wireless LAN and
	incorrect ESSID	enter or Autolearn it again if required.
	AP does not support appropriate data rates	Check the AP configuration against
		Configuration Note for AP.
	Out of range	Try getting closer to an AP. Check to see if
		other handsets are working within the
		same range of an AP. If so, check the
		ESSID of this handset.
	Incorrect Security settings	Verify that all the Security settings in the
		handset match those in the APs
No Net Found	x…x = AP MAC address	Check AP and handset network settings
xxxxxxxxxxxx yy	yy = AP signal strength	such as ESSID, Security, Reg domain and
	Handset cannot find a suitable access point;	Tx power.
	displays MAC and signal strength of “best”	Ensure APs are configured per
	non-suitable AP found.	Configuration Note.
		Try Site Survey mode to determine more
		specific cause.
No PBX IP Addr	The Handset could not locate the Mitel PBX.	If the handset is operating in static IP
		mode, make sure that the PBX IP address
		has been entered in the administrative
		menus under RTC IP Addr. In DHCP mode,
		ensure that the system administrator has
		properly entered the DHCP option
		parameters at the DHCP server.

PN: 72-1084-02-G.doc Page 56