Polycom 72-1084-02, SX-200 ICP, Mitel Networks 3300 manual Lan

SpectraLink Corporation	Configuration and Administration—NetLink e340/i640 Wireless Telephone
	Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
Message	Description	Action
No PBX Response	The handset has exceeded its retransmission	Verify that Call Agent IP address and port
	limit with no ACK response from Call Agent.	are properly configured.
No Reg Domain	Regulatory Domain Not Set	Configure the Regulatory Domain of the
		handset
No SVP IP	The handset is configured for “static IP” (as	Enter a valid NetLink SVP server IP address
	opposed to “use DHCP”) and no valid	in the configuration setting or change to
	NetLink SVP Server address has been	“use DHCP.”
	entered.
No SVP Response	y…y = SVP Server IP address	This may be caused by bad radio reception
yyy.yyy.yyy.yyy	Handset has lost contact with the SVP Server.	or a problem with the NetLink SVP Server.
		The handset will keep trying to fix the
		problem for 20 seconds, and the message
		may clear by itself. If it does not, the
		handset will restart. Report this problem to
		the system administrator if it keeps
		happening.
No SVP Server	Handset can’t locate NetLink SVP Server	IP address configuration of NetLink SVP
		Server is wrong or missing.
	NetLink SVP Server is not working	Check error status screen on NetLink SVP
		Server.
	No LAN connection at the NetLink SVP Server	Verify NetLink SVP Server connection to
		LAN.
No SVP Server	Handset unable to perform DNS lookup for	The network administrator must verify that
No DNS Entry	SVP Server, server had no entry for SVP	a proper IP address has been entered for
	Server	the SVP Server DHCP option.
No SVP Server	Handset unable to perform DNS lookup for	The network administrator must verify
No DNS IP	SVP Server, no IP address for DNS server	proper DHCP server operation.
No SW Found	A required software component has not been	Check that the handset license type has a
	identified.	corresponding entry in the slnk_cfg.cfg
		file.
		Check that the pd11mgd.bin and
		pi110000.bin entries exist in under this
		license type in the slnk.cfg.cfg file.
Not Installed!	A required software component is missing	Check that all required software files are
		on the TFTP server, if over-the-air
		downloading is being used. If the error
		repeats, contact SpectraLink Technical
		Support.
Press END Call	The far end of a call has hung up.	Hang up the near end.
Register to PBX	The handset is attempting to register to the	If this message persists, verify that the
	PBX.	handset is properly provisioned on the PBX
		and that the 5220 Emulation mode is set
		properly in the administrative menus.
Restart Command	The Handset received a restart command	None. The Handset will automatically
	from the supported Mitel Networks VoIP	restart in a few seconds.
	solution.

PN: 72-1084-02-G.doc Page 57