Uniden WDECT 2345+1 Turning the Answering System On/Off, Setting Your Outgoing Message Greeting

￿When the answering system is full, you will hear “No Remaining Time“ and

appears on the LCD. You should delete some messages

so that the system can record new messages.

Turning the Answering System On/Off

1) To turn the answering system on, press
	answer on/off on the base when the
phone is in standby mode or from the Answer
Setup menu. Message and the number of
messages stored in memory appear on the
LCD. If the LCD flashes, then there are
new messages waiting for you.		answer on/off on the base.
2) To turn the answering system off, press
ANSWER	Appears on the LCD.
OFF

Setting Your Outgoing Message (Greeting)

When you receive a call, the answering system automatically plays either the pre- recorded message or your own greeting. To record your own greeting, or choose between the two outgoing messages, refer to “Answering System Setup” on page 56. The following message is pre-recorded: "Hello, no one is available to take your call. Please leave a message after the tone.”

Announce only feature

The announce only feature plays a pre-recorded outgoing message or your own personal outgoing message, but it will not allow the caller to leave a message. To set announce only, follow the steps on "Setting the Record Time"

on page 58. If you want to use your own greeting and you want to change your greeting to omit the prompt to leave a message, refer to “Selecting Your Greeting (Base only)”on page 56. The following message is pre- recorded: "Hello, no one is available to take your call. Please call again.”

[61]