NEC ND-70895 (E) system manual NEAX2400 IMX DLC TSW

OFFICE DATA DESIGN

Procedure for Setting Office Data for OAI Services

2.This service cannot be used simultaneously with other MW control services (VMM/MCI: Message Center Interface/Message Waiting from Station, ATTCON and MAT).

3.The conditions for the telephone that controls MW are as follows.

•MW can be serviced only on a telephone equipped with MW lamp function.

•On a single-line telephone and/or Dterm, MW lamp display position is fixed.

•On a single-line telephone, MW lamp flashing cannot be controlled (ON/OFF only).

•MW lamp on/off/flashing, and LCD display can be controlled on a Dterm. (MW indication is available only on a Dterm equipped with the indicator.)

•Dterm can control only lamp flashing (LCD display cannot be controlled).

4. In the case of MW service by SSFR (Confirm-type <Computer → NEAX> Performer facility), the same kinds of display (MW, VMS) as those of MCI (Message Center Interface) are possible.

5.In the case of deletion of all the station data and all the type data, only the same data as those of MCI are deleted. MW service information for stations from the OAI Terminal Control Facility (TCF) are not deleted.

6.In the case of MW service by SSFR, lamp on/flashing/off is immediately indicated at the time of one station control. In the case of deletion of all the station data and all the type data, a delay time of maximum 196 seconds generates until the status of the terminal changes actually.

7.The system configuration for implementing this service is as illustrated below.

Terminal	NEAX2400 IMX
	DLC	TSW
(Dterm )
Single-Line
Telephone
with MWL	LC
				Computer
			OAI
				SSFR
				Appli-
		CPU	IP	cation
				Program
				(AP)

CHAPTER 5 ND-70895 (E)

Page 70

Revision 1.0