Panasonic KX-TG2522E, KX-TG2523E, KX-TG2524E, KX-TG2521E Error messages, Troubleshooting

Page 35

TG251x_2xE(e).book Page 35 Monday, January 25, 2010 3:09 PM

Useful Information

Error messages

If the unit detects a problem, one of the following messages is shown on the display.

Display message	Cause/solution
Error*1	L Recording was too short. Try again.
Failed*2	L Phonebook copy failed (page 19). Confirm the other
	handset (the receiver) is in standby mode and try
	again.
Incomplete*2	L The receiver’s phonebook memory is full. Erase the
	unnecessary phonebook entries from the other
	handset (the receiver) and try again.
Memory Full	L The phonebook memory is full. Erase unnecessary
	entries (page 18).
Messages Full*1	L Message memory is full. Erase unnecessary
	messages (page 27).*1
No link to base.	L The handset has lost communication with the base
Reconnect AC	unit. Move closer to the base unit and try again.
adaptor.	L Unplug the base unit’s AC adaptor to reset the unit.
	Reconnect the adaptor and try again.
	L The handset’s registration may have been cancelled.
	Re-register the handset (page 40).

*1 KX-TG2521/KX-TG2522/KX-TG2523/KX-TG2524 *2 KX-TG2522/KX-TG2523/KX-TG2524

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the base unit’s AC adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on the handset.

General use

Problem	Cause/solution
The handset does not	L Place the handset on the base unit or charger
automatically turn on even after	to turn on the handset.
installing charged batteries.

			Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333				35

Image 35

Contents Before initial use, see Getting Started on Important Information Caller ID ServiceVoice Mail Service IntroductionSeries Model No Base unit Handset Quantity Accessory informationSupplied accessories Model compositionHelpline Tel. No. U.K 844 3898 R.O.I Additional/replacement accessoriesAccessory item Model number Customer Care Centre Sales and support informationDeclaration of Conformity General informationFor your future reference For your safety Important safety instructions Other information Operating conditions Connections Setting upBattery installation Battery chargeOperation Operating time During a power failureBattery level Icon Base unit ControlsDisplay HandsetDisplay language Turning the power on/offInitial settings Handset Setup Display Setup Select LanguageDate and time One touch eco modeHandset Setup Set Date & Time Answering calls Making callsRecall/flash Useful features during a callHold MuteEditing entries Handset phonebookAdding entries Finding and calling a phonebook entryCopying all entries Copying phonebook entriesCopying an entry Programming by scrolling through the display menus Programmable settingsRegister H.set Handset SetupRinger Setup Ringer Volume *3 Increasing the range of the base unit Setting the repeater modeBase Unit Setup Repeater Mode Special programmingViewing the caller list and calling back Using Caller ID serviceCaller ID features Caller listErase or Erase All Erasing caller informationStoring caller information to the phonebook Edit and CallCall screening Answering systemTurning the answering system on/off Memory capacity including your greeting messageRecording your greeting message Using a pre-recorded greeting messageGreeting message Listening to messagesErasing all messages Remote operationOperating the answering system Calling back Caller ID subscribers onlyVoice guidance Remote access codeUsing the answering system remotely Remote commandsNumber of rings before the unit answers a call Answering system settingsFor voice mail service subscribers Turning on the answering system remotelyRecording Time Caller’s recording timeVoice mail service Answering an intercom call Intercom Transferring calls Conference calls Handset locator Making an intercom callCharacter entry modes When the unit displays the character entry screenCharacter entry Extended 2 character table O Extended 1 character table NTroubleshooting Error messagesProgrammable settings Problem Cause/solution Problem Cause/solutionMaking/answering calls, intercom Problem Cause/solution Base Unit SetupBattery recharge Problem Cause/solution Caller ID Problem Cause/solution Unit does not Registering a handset to the base unit Handset Liquid damage Problem Cause/solutionHandset Setup ij/OK Register H.set ij/OK Base unit Charger Base Unit Setup ij/OK Base Unit PIN ij/OKWall mounting Changing the base unit PIN Personal Identification NumberPanasonic Business Systems U.K Conditions of guaranteeIndex Copyright Sales Department