Sharp XL-DAB20NH Troubleshooting chart continue Maintenance, Factory reset, clearing all memory

Troubleshooting chart (continue) Maintenance

■Factory reset, clearing all memory

1Press the ON/STAND-BY button to enter the power stand-by mode.

2Whilst pressing down the OPEN/CLOSE button, press the ON/STAND-BY button until “RESET” appears.

Caution:

This operation will erase all data stored in memory including clock, timer settings, tuner preset, and CD programme.

■Before transporting the unit

Remove the iPod, USB memory device and disc from the unit. Then, set the unit to the power stand-by mode. Carrying the unit with iPod or USB memory device left docked or discs left inside might damage the unit.

■Care of compact discs

Compact discs are fairly resistant to damage, however mistracking can occur due to an accumulation of dirt on the disc surface. Follow the guidelines below for maximum enjoyment from your CD collection and player.

●Do not write on either side of the disc, particularly the non-label side from which signals are read. Do not mark this surface.

●Keep your discs away from direct sunlight, heat, and excessive moisture.

●Always hold the CDs by the edges. Fingerprints, dirt, or water on the CDs can cause noise or mistracking. If a CD is dirty or does not play properly, clean it with a soft, dry cloth, wiping straight out from the centre, along the radius.

NO	YES
	Correct

■Cleaning the cabinet

Periodically wipe the cabinet with a soft cloth and a diluted soap solution, then with a dry cloth.

Caution:

●Do not use chemicals for cleaning (petrol, paint thinner, etc.). It may damage the cabinet.

●Do not apply oil to the inside of the unit. It may cause malfunctions.

E-23