Remote control (continued) | General control | |
|
|
|
Notes concerning use:
●Replace the batteries if the operating distance is reduced or if the operation becomes erratic. Purchase 2 “AAA” size batteries
●Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth.
●Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs.
●Keep the remote control away from moisture, heat, shock, and vibrations.
■Test of the remote control
Check the remote control after checking all the connections.
Point the remote control directly at the remote sensor on the unit. The remote control can be used within the range shown below:
Remote sensor
0.2 m - 6 m
(8" - 20')
■To turn the power on
Press the
After use:
Press the
■Volume auto set-in
●If you turn off and on the main unit with volume set to 16 or higher, the volume will start at 16.
●If you turn the unit off then on again with the volume level set to less than 15, it will turn on again at the level set.
■Volume control
Turn the volume knob towards VOL +/– (on main unit) or press VOLUME +/– (on remote control) to increase or decrease the volume.
■Extra bass control (X-BASS)
When the
To cancel the extra bass mode, press the
■Auto power off function
The main unit will enter the
iPod : No connection.
CD/USB : In the stop mode.
DAB : No reception of broadcast signal.
AUX IN : No detection of input signal or very low sound audibility.
■Muting
The volume is muted temporarily when pressing the MUTE button on the remote control. Press again to restore the volume.
