Listening to the DAB+
■About DAB+ (Digital Audio Broadcasting)
Digital Audio Broadcasting is a digital transmission system where audio signals are converted to digital signals for broadcasting. DAB+ is broadcast as a group of data called multiplex (ensemble) which may contain one or more stations (services). Each station contains a primary service and there may be one or more secondary services. This allows several programmes or services to be transmitted on a single frequency.
DAB + SIGNAL
MULTIPLEX (ENSEMBLE)
SERVICES
SERVICES COMPONENTS (STATIONS)
■Auto tune
When turned on for the first time, the unit scans radio stations automatically to create a station list. You can make the AUTOTUNE again when you move the unit to other areas or add multiplex channels to the station list.
1Press the DAB button until “DAB” appears on the display.
2Press DAB SCAN button on the remote control for more than 3 seconds. AUTOTUNE scanning begins.
The scanning progress is indicate by advancing asterisks.
The number of received station
After the scan:
The stations will be stored in alphanumeric order and the first station on the list will be selected and you will hear it through the speakers.
●To listen to other stations, see “Selecting a station in the station list” on page 18.
Notes:
●If no station is found, “NO STN” appears.
●Up to 99 appears for total received stations.
■Selecting a station in the station list
Once a DAB+ station is received, you can select stations in the station list.
1Press the DAB button until “DAB” appears on the display.
2Whilst receiving a DAB+ station, press the TUNING/ FOLDER (
or 
) to select the desired station.
Display current station
The name of the station being selected
3Within 10 seconds, press the DAB ENTER button on the remote control to tune into the desired station.
■Manual tune
You can manually store stations which AUTOTUNE cannot find. If reception is poor, you can adjust the sensitivity. Manual tune is only available after Auto tune. Perform AUTOTUNE first.
1Press the DAB button until “DAB” appears on the display.
2Press the DAB SCAN button
once.
3 Within 10 seconds, press the TUNING/ FOLDER ( 
or 
) to select the DAB+ frequency.
4Within 10 seconds, press the DAB
ENTER button.
●Reception sensitivity appears. The percentage number indicate the current level.
●If the level is too low, move the aerial or unit to improve reception.
5Press the DAB ENTER button again to store the station and exit manual tune.
