System connections

Make sure to unplug the AC power lead before making any connections.

 

Video cable

TV

(not supplied)

 

To video

 

input socket

Right speaker

Red

Black

DAB/FM Aerial

Left speaker

Wall socket

(AC 220 - 240 V ~ 50/60 Hz)

Speaker connection

Connect the black wire to the minus

(–) terminal, and the red wire to the

 

plus (+) terminal.

 

Use speakers with an impedance of

 

6 ohms or more, as lower

 

impedance speakers can damage

 

the unit.

 

Do not mistake the right and the left

 

channels. The right speaker is the

Incorrect

one on the right side when you face

 

the unit.

 

Do not let the bare speaker wires touch each other.

Do not allow any objects to fall into or to be placed in the bass reflex ducts.

Do not stand or sit on the speakers. You may be injured.

Connecting iPod to a TV

The iPod with photo and video can be viewed by connecting to a TV/monitor.

If the TV/monitor has a video input, connect it to the VIDEO OUT socket on the rear of the unit.

Note:

Please make sure to set iPod unit to either NTSC or PAL to match your TV signal. Please visit Apple’s home page for further information.

AC power connection

After checking all the connections have been made correctly, plug the AC power lead of this unit into the wall socket. If you plug in the unit first, the unit will enter the stand-by mode.

Note:

Unplug the AC power lead from the wall socket if the unit will not be in use for a prolonged period of time.

Remote control

Battery installation

1Open the battery cover.

2Insert the batteries according to the direction indicated in the battery compartment.

When inserting or removing the batteries, push them towards the (–) battery terminals.

3Close the cover.

Caution:

Replace all old batteries with new ones at the same time.

Do not mix old and new batteries.

Remove the batteries if the unit will not be used for a long period of time. This will prevent potential damage due to battery leakage.

Do not use rechargeable batteries (nickel-cadmium battery, etc.).

Installing the batteries incorrectly may cause the unit to malfunction.

Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.

E-4

Page 13
Image 13
Sharp XL-DAB10NH, XL-DAB20NH operation manual System connections, Remote control