Panasonic KX-TG1810AL Operating additional units, Registering a handset to a base unit

Page 56

TG1810_1822AL(e-e).book Page 56 Tuesday, March 1, 2005 6:46 PM

Multi-unit Operation

Operating additional units

Additional handsets

Up to 6 handsets can be registered to a single base unit. Additional handsets will give you the freedom to, for example, have an intercom call with another handset while a third handset is on an outside call. See page 6 for information on ordering additional handsets.

Important:

LThe additional handset model recommended for use with this unit is noted on page 6. If other model handset is used, certain operations (handset settings, base unit settings, etc.) may not be available.

Additional base units

Handsets can be registered to up to 4 base units, allowing you to add additional base units and extend the area in which your handset(s) can be used. If a handset moves out of range of its base unit when “Auto” is selected on base unit selection (page 57), it will look for another base unit to make or receive calls. A base unit and the handsets it communicates with is called a “radio cell”.

Note:

LCalls will be disconnected when the handset moves from one radio cell to another.

LIntercom calls and call transfers are only possible between handsets in the same radio cell.

Registering a handset to a base unit

To register an additional handset to a base unit (easy registration)

The included handset and base unit are preregistered. After purchasing an additional handset, register it to the base unit. Ensure that the additional handset is switched on. If it is not on, press and hold {ih} for few seconds to turn the handset on.

1Lift the additional handset and press {ih} to put the handset in standby mode.

2Press and hold {x} on the base unit for about 3 seconds, until the registration tone sounds.

3Place the additional handset on the base unit. The registration tone continues to sound. With the handset still on the base unit, wait until a confirmation tone sounds and w stops flashing.

Note:

LIf an error tone sounds, or if w is still flashing, register the handset manually (manual registration; page 57).

LIf all registered handsets start ringing in step 2, press {x} to stop. Start again from step 1.

LCharge the batteries of your additional handset for about 7 hours before initial use.

LThis registration method cannot be used for handsets that have already been registered to a base unit. Register the handset manually (manual registration; page 57).

56

Page 55 Page 57
Image 56
Page 55 Page 57
Contents Model No. KX-TG1810AL Introduction TrademarksFeature highlights Polyphonic ringtones for handset Making/Answering Calls Accessory information Included accessoriesAdditional/replacement accessories Model No DescriptionBattery caution Important informationGeneral EnvironmentTG18101822ALe-e.book Page 8 Tuesday, March 1, 2005 646 PM Installation Instructions to customerService difficulties Controls and displays ControlsDisplays Charger KX-TG1822 only Charge contactDisplay icons Display Meaning IconConnections Charger KX-TG1822 onlyBattery installation Battery chargeSetting the date and time Battery replacementTurning the power on/off Example 330 PM Redial feature Making callsOther features To erase numbers in the redial listVoice enhancer MuteAnswering calls Handset locator Handset phonebook Editing entries in the handset Phonebook Erasing entries from the handsetOne touch dial Erasing a one touch dial assignment Making a call using a one touch dial keyChain dial Shared phonebook KX- TG1822 only Adding entries to the shared phonebookFinding and calling a shared phonebook entry Searching by first character index searchEditing entries in the shared phonebook Erasing entries from the shared phonebookChanging a name, phone number, audible call Playing back an audible call announcementCopying phonebook entries Copying handset phonebook entries to other handsetCopying one entry Copying all entriesGuide to handset settings Handset settings Sub-menu Default setting MenuChanging ringtones Ringer setupRinger volume Night mode Setting the start and end time for night modeTurning night mode on/off Setting the ring delay for night modeDisplay setup Selecting the standby mode displaySelecting categories to bypass night mode Changing the display languageOther options Call optionsResetting the handset to its default settings Turning keytones on/offGuide to base unit settings Base unit Sub-menu Default setting Settings menuNight mode Storing/changing emergency numbers Setting pause lengthChanging the recall time Selecting area codes to be deleted automatically Setting call restrictionChanging the base unit PIN Personal Identification Number Resetting the base unit to its default settings Call waiting and Caller ID compatible Using Caller ID serviceCategory features for handset phonebook Caller list Audible call for shared phonebook KX-TG1822 onlyViewing the caller list and calling back Editing a caller’s phone number before calling backVoice mail service Storing caller information into the handset phonebookTurning SMS on/off Using SMS Short Message ServiceUsing public mailbox and private mailboxes Sending a message Writing and sending a new messageReceiving a message Sending a saved messageEditing and sending a saved message Erasing saved messagesReading a received message Replying to a messageErasing received messages Storing the sender’s number in the handset phonebookGuide to SMS settings SMS settings Default SettingEditing the sender’s number before calling back Creating private mailboxesChanging private mailbox settings Storing the PBX line access number for PBX users onlyLetterWise character table for English Available character entries for SMSCharacter entry modes LThe following are used for both uppercase and lowercase Using a prerecorded greeting message Answering systemGreeting message Recording a greeting messageListening to messages Erasing the greeting messageListening to new/all messages Erasing all messagesRecording a voice memo Memory capacityUsing direct commands Using the answering system remotelyKey Direct commands Remote operationRemote commands Key Remote commandTurning on the answering system remotely Voice guidanceAnswering Default System setting Setting For voice mail service subscribersChanging the number of rings Selecting the caller’s recording timeTurning call screening on/off Turning message alert on/offOperating additional units Registering a handset to a base unitAdditional handsets Additional base unitsCancelling a handset Selecting a base unitIncreasing the range of the base unit Cancelling a base unitTurning the repeater mode on/off Transferring calls between handsets, conference calls Wall mounting Wall mounting the base unitWall mounting the charger KX-TG1822 only 25 mm ScrewsAvailable character entries TG18101822ALe-e.book Page 63 Tuesday, March 1, 2005 646 PM Extended 2 character table O Cyrillic character table PProblem Cause & solution TroubleshootingInitial settings Telephone Redial the number manually SMS Short Message Service Answering system KX-TG1822 only Specifications Index PINSpeakerphone Wall mounting TG18101822ALe-e.book Page 73 Tuesday, March 1, 2005 646 PM TG18101822ALe-e.book Page 74 Tuesday, March 1, 2005 646 PM TG18101822ALe-e.book Page 75 Tuesday, March 1, 2005 646 PM Sales Department Panasonic Australia Pty. Limited Copyright

KX-TG1822AL, KX-TG1810AL specifications

The Panasonic KX-TG1810AL and KX-TG1822AL are part of Panasonic's reliable and well-designed cordless telephone range, known for their user-friendly features and advanced technologies. These models combine functionality with modern aesthetics, making them an excellent choice for both home and office environments.

One of the standout features of these models is their DECT technology, ensuring excellent sound quality and a stable connection. DECT (Digital Enhanced Cordless Telecommunications) minimizes interference from other wireless devices, providing crystal-clear audio for uninterrupted conversations. The KX-TG1810AL offers a single handset, while the KX-TG1822AL provides a double-handset option, catering to different user needs.

The KX-TG1810AL and KX-TG1822AL come equipped with a large, easy-to-read LCD display that enhances visibility, especially in low-light conditions. The intuitive interface allows for seamless navigation through the phone's numerous features, including caller ID, call waiting, and a built-in phonebook that can store up to 50 contacts. This is particularly useful for those who frequently receive calls from important contacts.

Another notable technology present in these models is the ECO mode, which significantly reduces power consumption. This energy-efficient feature not only contributes to lower electricity bills but also promotes environmental sustainability. When engaged, ECO mode reduces the signal strength when the handset is close to the base unit, minimizing energy use without sacrificing performance.

Both models feature a long battery life, with the KX-TG1810AL and KX-TG1822AL providing up to 18 hours of talk time and several days on standby. This reliability means users can have extended conversations without the constant need to recharge their devices.

For added convenience, these telephones allow for intercom functionality between handsets in the KX-TG1822AL model, making them ideal for larger households or offices where communication between different rooms is essential.

Overall, the Panasonic KX-TG1810AL and KX-TG1822AL offer a blend of advanced features, energy efficiency, and ease of use, making them solid options for anyone in need of reliable and functional cordless telephones. Their ergonomic design and user-friendly interface further enhance the overall user experience, ensuring that making and receiving calls is straightforward and enjoyable.
Top Page Image Contents