Panasonic KX-TG1810AL, KX-TG1822AL Cancelling a base unit, Increasing the range of the base unit

Page 58

TG1810_1822AL(e-e).book Page 58 Tuesday, March 1, 2005 6:46 PM

Multi-unit Operation

Cancelling a base unit

A handset can be registered to a maximum of 4 base units. A handset can cancel a base unit that it is registered to. This allows the handset to “forget” the base unit.

1Press {j/OK}.

2Select Handset Setup, then press

{>}.

3Select Registration, then press

{>}.

4Enter 335.

5Select Cancel Base, then press

{>}.

6Enter 0000(default handset PIN).

LIf you changed the PIN, enter it (page 31).

7Select the base unit(s) you want to cancel, by pressing the desired base unit number.

LThe selected base unit number(s) will flash.

LTo cancel a selected base unit number, press the number again. The number will stop flashing.

8Press {j/OK}.

9Select Yes, then press {>}.

10Press {ih}.

Note:

LTo register the handset to another base unit or to the same base unit again, see manual registration (page 57).

Increasing the range of the base unit

You can increase the range of the base unit by using a DECT repeater. Please use only the Panasonic DECT repeater noted on page 6. Consult your Panasonic dealer for details.

Important:

LBefore registering the repeater to this base unit, you must turn the repeater mode on.

Turning the repeater mode on/off

1Press {j/OK}.

2Select Base Unit Setup, then press {>}.

3Enter 0000(default base unit PIN). LIf you changed the PIN, enter it (page

36).

4Select Other Options, then press

{>}.

5Select Repeater Mode, then press

{>}.

6Select Onor Off, then press {>}.

7Press {ih}.

Note:

LAfter turning repeater mode on/off, you will not be able to make or receive calls for a few moments.

LWhile the repeater mode is turned on, audible call announcements may not be heard (KX-TG1822 only).

Intercom between handsets

Intercom calls can be made between handsets in the same radio cell, but not between handsets in different radio cells. Example: When handset 1 calls handset 2

1Handset 1:

Press {INT} and {2} (desired handset number).

2Handset 2:

Press {C} or {s} to answer.

3When finished talking, press {ih}.

58

Image 58
Contents Model No. KX-TG1810AL Introduction TrademarksFeature highlights Polyphonic ringtones for handset Making/Answering Calls Additional/replacement accessories Accessory informationIncluded accessories Model No DescriptionGeneral Battery cautionImportant information EnvironmentTG18101822ALe-e.book Page 8 Tuesday, March 1, 2005 646 PM Installation Instructions to customerService difficulties Controls and displays ControlsDisplay icons DisplaysCharger KX-TG1822 only Charge contact Display Meaning IconConnections Charger KX-TG1822 onlyBattery installation Battery chargeTurning the power on/off Battery replacementSetting the date and time Example 330 PM Redial feature Making callsVoice enhancer Other featuresTo erase numbers in the redial list MuteAnswering calls Handset locator Handset phonebook One touch dial Erasing entries from the handsetEditing entries in the handset Phonebook Chain dial Making a call using a one touch dial keyErasing a one touch dial assignment Finding and calling a shared phonebook entry Shared phonebook KX- TG1822 onlyAdding entries to the shared phonebook Searching by first character index searchChanging a name, phone number, audible call Editing entries in the shared phonebookErasing entries from the shared phonebook Playing back an audible call announcementCopying one entry Copying phonebook entriesCopying handset phonebook entries to other handset Copying all entriesGuide to handset settings Handset settings Sub-menu Default setting MenuRinger volume Ringer setupChanging ringtones Turning night mode on/off Night modeSetting the start and end time for night mode Setting the ring delay for night modeSelecting categories to bypass night mode Display setupSelecting the standby mode display Changing the display languageOther options Call optionsResetting the handset to its default settings Turning keytones on/offGuide to base unit settings Base unit Sub-menu Default setting Settings menuNight mode Changing the recall time Setting pause lengthStoring/changing emergency numbers Changing the base unit PIN Personal Identification Number Setting call restrictionSelecting area codes to be deleted automatically Resetting the base unit to its default settings Category features for handset phonebook Using Caller ID serviceCall waiting and Caller ID compatible Viewing the caller list and calling back Caller listAudible call for shared phonebook KX-TG1822 only Editing a caller’s phone number before calling backVoice mail service Storing caller information into the handset phonebookUsing public mailbox and private mailboxes Using SMS Short Message ServiceTurning SMS on/off Sending a message Writing and sending a new messageEditing and sending a saved message Receiving a messageSending a saved message Erasing saved messagesErasing received messages Reading a received messageReplying to a message Storing the sender’s number in the handset phonebookEditing the sender’s number before calling back Guide to SMS settingsSMS settings Default Setting Creating private mailboxesChanging private mailbox settings Storing the PBX line access number for PBX users onlyCharacter entry modes Available character entries for SMSLetterWise character table for English LThe following are used for both uppercase and lowercase Greeting message Using a prerecorded greeting messageAnswering system Recording a greeting messageListening to new/all messages Listening to messagesErasing the greeting message Erasing all messagesRecording a voice memo Memory capacityKey Direct commands Using direct commandsUsing the answering system remotely Remote operationTurning on the answering system remotely Remote commandsKey Remote command Voice guidanceChanging the number of rings Answering Default System setting SettingFor voice mail service subscribers Selecting the caller’s recording timeTurning call screening on/off Turning message alert on/offAdditional handsets Operating additional unitsRegistering a handset to a base unit Additional base unitsCancelling a handset Selecting a base unitTurning the repeater mode on/off Cancelling a base unitIncreasing the range of the base unit Transferring calls between handsets, conference calls Wall mounting Wall mounting the base unitWall mounting the charger KX-TG1822 only 25 mm ScrewsAvailable character entries TG18101822ALe-e.book Page 63 Tuesday, March 1, 2005 646 PM Extended 2 character table O Cyrillic character table PInitial settings TroubleshootingProblem Cause & solution Telephone Redial the number manually SMS Short Message Service Answering system KX-TG1822 only Specifications Index PINSpeakerphone Wall mounting TG18101822ALe-e.book Page 73 Tuesday, March 1, 2005 646 PM TG18101822ALe-e.book Page 74 Tuesday, March 1, 2005 646 PM TG18101822ALe-e.book Page 75 Tuesday, March 1, 2005 646 PM Sales Department Panasonic Australia Pty. Limited Copyright

KX-TG1822AL, KX-TG1810AL specifications

The Panasonic KX-TG1810AL and KX-TG1822AL are part of Panasonic's reliable and well-designed cordless telephone range, known for their user-friendly features and advanced technologies. These models combine functionality with modern aesthetics, making them an excellent choice for both home and office environments.

One of the standout features of these models is their DECT technology, ensuring excellent sound quality and a stable connection. DECT (Digital Enhanced Cordless Telecommunications) minimizes interference from other wireless devices, providing crystal-clear audio for uninterrupted conversations. The KX-TG1810AL offers a single handset, while the KX-TG1822AL provides a double-handset option, catering to different user needs.

The KX-TG1810AL and KX-TG1822AL come equipped with a large, easy-to-read LCD display that enhances visibility, especially in low-light conditions. The intuitive interface allows for seamless navigation through the phone's numerous features, including caller ID, call waiting, and a built-in phonebook that can store up to 50 contacts. This is particularly useful for those who frequently receive calls from important contacts.

Another notable technology present in these models is the ECO mode, which significantly reduces power consumption. This energy-efficient feature not only contributes to lower electricity bills but also promotes environmental sustainability. When engaged, ECO mode reduces the signal strength when the handset is close to the base unit, minimizing energy use without sacrificing performance.

Both models feature a long battery life, with the KX-TG1810AL and KX-TG1822AL providing up to 18 hours of talk time and several days on standby. This reliability means users can have extended conversations without the constant need to recharge their devices.

For added convenience, these telephones allow for intercom functionality between handsets in the KX-TG1822AL model, making them ideal for larger households or offices where communication between different rooms is essential.

Overall, the Panasonic KX-TG1810AL and KX-TG1822AL offer a blend of advanced features, energy efficiency, and ease of use, making them solid options for anyone in need of reliable and functional cordless telephones. Their ergonomic design and user-friendly interface further enhance the overall user experience, ensuring that making and receiving calls is straightforward and enjoyable.