Panasonic KX-TG1822AL, KX-TG1810AL Selecting a base unit, Cancelling a handset

Page 57

TG1810_1822AL(e-e).book Page 57 Tuesday, March 1, 2005 6:46 PM

Multi-unit Operation

To register a handset to an additional base unit (manual registration)

You can register a handset to a base unit manually using the following method.

1Press {j/OK}.

2Select “Handset Setup”, then press

{>}.

3Select “Registration”, then press {>} 2 times.

4Select a base unit number, then press

{>}.

LThis number is used by the handset as a reference only.

5Press and hold {x} on the base unit for about 3 seconds, until the registration tone sounds.

LIf all registered handsets start ringing, press {x} to stop, then repeat this step.

LAfter pressing {x}, the rest of this procedure must be completed within 1 minute.

6Wait until “Enter Base PIN” is displayed, then enter “0000” (default base unit PIN), then press {j/OK}.

LIf you changed the PIN, enter it (page 36).

LWhen the handset has been registered successfully, w will stop flashing. If keytones are turned on (page 32), a confirmation tone will be heard.

Selecting a base unit

When “Auto” is selected, the handset will automatically use any available base unit it is registered to. When a specific base unit is selected, the handset will make and receive calls using that base unit only. If the handset is out of range of that base unit, no calls can be made.

1Press {j/OK}.

2Select “Handset Setup”, then press

{>}.

3Select “Select Base”, then press

{>}.

4Select the desired base unit number, or “Auto”, then press {>}.

LThe handset starts searching for the base unit.

Cancelling a handset

A maximum of 6 handsets can be registered to a base unit. A handset can cancel its own registration (or the registration of another handset) that is stored in the base unit. This will allow the base unit to “forget” the handset.

1Press {j/OK}.

2Select “Base Unit Setup”, then press {>}.

3Enter “0000” (default base unit PIN). LIf you changed the PIN, enter it (page

36).

4Enter “335”.

5Select “Cancel Handset”, then press

{>}.

LThe numbers of all handsets registered to the base unit are displayed.

6Select the handset(s) you want to cancel, by pressing the desired handset number.

LThe selected handset number(s) will flash.

LTo cancel a selected handset number, press the number again. The number will stop flashing.

7Press {j/OK}.

8Select “Yes”, then press {>}.

9Press {ih}.

57

Page 56 Page 58
Image 57
Page 56 Page 58
Contents Model No. KX-TG1810AL Trademarks IntroductionFeature highlights Polyphonic ringtones for handset Making/Answering Calls Included accessories Accessory informationAdditional/replacement accessories Model No DescriptionImportant information Battery cautionGeneral EnvironmentTG18101822ALe-e.book Page 8 Tuesday, March 1, 2005 646 PM Instructions to customer InstallationService difficulties Controls Controls and displaysCharger KX-TG1822 only Charge contact DisplaysDisplay icons Display Meaning IconCharger KX-TG1822 only ConnectionsBattery charge Battery installationBattery replacement Turning the power on/offSetting the date and time Example 330 PM Making calls Redial featureTo erase numbers in the redial list Other featuresVoice enhancer MuteAnswering calls Handset locator Handset phonebook Erasing entries from the handset One touch dialEditing entries in the handset Phonebook Making a call using a one touch dial key Chain dialErasing a one touch dial assignment Adding entries to the shared phonebook Shared phonebook KX- TG1822 onlyFinding and calling a shared phonebook entry Searching by first character index searchErasing entries from the shared phonebook Editing entries in the shared phonebookChanging a name, phone number, audible call Playing back an audible call announcementCopying handset phonebook entries to other handset Copying phonebook entriesCopying one entry Copying all entriesHandset settings Sub-menu Default setting Menu Guide to handset settingsRinger setup Ringer volumeChanging ringtones Setting the start and end time for night mode Night modeTurning night mode on/off Setting the ring delay for night modeSelecting the standby mode display Display setupSelecting categories to bypass night mode Changing the display languageCall options Other optionsTurning keytones on/off Resetting the handset to its default settingsBase unit Sub-menu Default setting Settings menu Guide to base unit settingsNight mode Setting pause length Changing the recall timeStoring/changing emergency numbers Setting call restriction Changing the base unit PIN Personal Identification NumberSelecting area codes to be deleted automatically Resetting the base unit to its default settings Using Caller ID service Category features for handset phonebookCall waiting and Caller ID compatible Audible call for shared phonebook KX-TG1822 only Caller listViewing the caller list and calling back Editing a caller’s phone number before calling backStoring caller information into the handset phonebook Voice mail serviceUsing SMS Short Message Service Using public mailbox and private mailboxesTurning SMS on/off Writing and sending a new message Sending a messageSending a saved message Receiving a messageEditing and sending a saved message Erasing saved messagesReplying to a message Reading a received messageErasing received messages Storing the sender’s number in the handset phonebookSMS settings Default Setting Guide to SMS settingsEditing the sender’s number before calling back Creating private mailboxesStoring the PBX line access number for PBX users only Changing private mailbox settingsAvailable character entries for SMS Character entry modesLetterWise character table for English LThe following are used for both uppercase and lowercase Answering system Using a prerecorded greeting messageGreeting message Recording a greeting messageErasing the greeting message Listening to messagesListening to new/all messages Erasing all messagesMemory capacity Recording a voice memoUsing the answering system remotely Using direct commandsKey Direct commands Remote operationKey Remote command Remote commandsTurning on the answering system remotely Voice guidanceFor voice mail service subscribers Answering Default System setting SettingChanging the number of rings Selecting the caller’s recording timeTurning message alert on/off Turning call screening on/offRegistering a handset to a base unit Operating additional unitsAdditional handsets Additional base unitsSelecting a base unit Cancelling a handsetCancelling a base unit Turning the repeater mode on/offIncreasing the range of the base unit Transferring calls between handsets, conference calls Wall mounting the base unit Wall mounting25 mm Screws Wall mounting the charger KX-TG1822 onlyAvailable character entries TG18101822ALe-e.book Page 63 Tuesday, March 1, 2005 646 PM Cyrillic character table P Extended 2 character table OTroubleshooting Initial settingsProblem Cause & solution Telephone Redial the number manually SMS Short Message Service Answering system KX-TG1822 only Specifications PIN IndexSpeakerphone Wall mounting TG18101822ALe-e.book Page 73 Tuesday, March 1, 2005 646 PM TG18101822ALe-e.book Page 74 Tuesday, March 1, 2005 646 PM TG18101822ALe-e.book Page 75 Tuesday, March 1, 2005 646 PM Copyright Sales Department Panasonic Australia Pty. Limited

KX-TG1822AL, KX-TG1810AL specifications

The Panasonic KX-TG1810AL and KX-TG1822AL are part of Panasonic's reliable and well-designed cordless telephone range, known for their user-friendly features and advanced technologies. These models combine functionality with modern aesthetics, making them an excellent choice for both home and office environments.

One of the standout features of these models is their DECT technology, ensuring excellent sound quality and a stable connection. DECT (Digital Enhanced Cordless Telecommunications) minimizes interference from other wireless devices, providing crystal-clear audio for uninterrupted conversations. The KX-TG1810AL offers a single handset, while the KX-TG1822AL provides a double-handset option, catering to different user needs.

The KX-TG1810AL and KX-TG1822AL come equipped with a large, easy-to-read LCD display that enhances visibility, especially in low-light conditions. The intuitive interface allows for seamless navigation through the phone's numerous features, including caller ID, call waiting, and a built-in phonebook that can store up to 50 contacts. This is particularly useful for those who frequently receive calls from important contacts.

Another notable technology present in these models is the ECO mode, which significantly reduces power consumption. This energy-efficient feature not only contributes to lower electricity bills but also promotes environmental sustainability. When engaged, ECO mode reduces the signal strength when the handset is close to the base unit, minimizing energy use without sacrificing performance.

Both models feature a long battery life, with the KX-TG1810AL and KX-TG1822AL providing up to 18 hours of talk time and several days on standby. This reliability means users can have extended conversations without the constant need to recharge their devices.

For added convenience, these telephones allow for intercom functionality between handsets in the KX-TG1822AL model, making them ideal for larger households or offices where communication between different rooms is essential.

Overall, the Panasonic KX-TG1810AL and KX-TG1822AL offer a blend of advanced features, energy efficiency, and ease of use, making them solid options for anyone in need of reliable and functional cordless telephones. Their ergonomic design and user-friendly interface further enhance the overall user experience, ensuring that making and receiving calls is straightforward and enjoyable.
Top Page Image Contents