Panasonic KX-TG2352PW, KX-TG2352W For assistance, please call 1-800-211-PANA7262

Page 65

WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR) MAKING TEST CALLS TO EMERGENCY NUMBERS:

1)Remain on the line and briefly explain to the dispatcher the reason for the call.

2)Perform such activities in the off-peak hours, such as early morning or late evenings.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

Privacy of communications may not be ensured when using this phone.

CAUTION:

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this device.

Note:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

Some cordless telephones operate at frequencies that may cause interference to nearby TVs and VCRs. To minimize or prevent such interference, the base of the cordless telephone should not be placed near or on top of a TV or VCR. If interference is experienced, move the cordless telephone further away from the TV or VCR. This will often reduce, or eliminate, interference.

Operating near 2.4GHz electrical appliances may cause interference. Move away

from the electrical appliances.Useful Information

For assistance, please call: 1-800-211-PANA(7262)

65

Page 64 Page 66
Image 65
Page 64 Page 66
Contents Operating Instructions Charge the battery for about 15 hours before initial useEnergy Star Attach your purchase receipt hereBase Unit Location/Noise Battery ChargeFor Best Performance Contents Storing Names and Numbers Canceling the Handset RegistrationALL, 1 to 3 p Charge Contacts p Charge Indicator pHandset Locator Buttons Handset How to use the Navigator keyConnections InstallationBase unit Charger unitBattery Charge Installing the Battery in the HandsetBattery information Battery strengthDisplay prompt Battery strength RechargeOptional Headset Belt ClipProgramming Guidelines Programmable SettingsHow to select a function item from the menu Useful information Function Menu TableSelect Pulse or Tone by pressing Ö or Press á Save key Dialing ModeGF H=Save Line ModeSelect a or B by pressing Ö or Ñ Press á Save key Select On or Off by pressing Ö or Ñ Press á Save key Auto Talk FeatureScroll to Ringer setting by pressing Ö or Ñ, and press á Ringer VolumeSelect the desired volume by pressing Ö or Ñ To turn the ringer onLCD Contrast Ringer setting HInitial set Hlcd contrast Auto talkLCD contrast Low High =Save LCD contrast Low HighPress ALL on base for 3 sec, then press H Base unitHandset Handset RegisteringBack side Registration for Additional HandsetsHands-free Digital Duplex Speakerphone To dial after confirming the entered number To redial using the redial list Memory RedialTo redial the last number dialed on the handset Press or and press PAUSE/REDIALTo release the hold To put a call on holdLighted handset keypad Backlit LCD displayAuto Talk Answering CallsHow caller information is displayed when a call is received Caller ID ServiceViewing the Caller List Using the Caller List12344567890 Editing the Caller’s Phone Number Ringer setting Caller ID Number Auto Edit FeatureScroll to Initial set by pressing Ö or Ñ HInitial setScroll to Save directory by pressing Ö or Ñ, and press á Storing Caller List Information in the DirectoryEnter name IH G=NextTo erase a specific caller from the Caller List Erasing Caller List InformationTo erase all entries in the Caller List Caller list 10 new calls GF H=DirectoryDirectory Tom Jones =Edit H=Save Press Ö Next key Enter a phone number, up to 22 digitsIf you make a mistake while entering a name Selecting characters to enter namesFor example, to enter Tom Jones Press Ü or á to enter the directory list Dialing from the DirectoryScroll to the desired item by pressing Ö or Ñ To search for a name by initialEditing When finished, press á Save keyPress Ö Next key Add a number to the current number Press Ö Next keyHelen Clear? =No CLEAR=Yes ErasingIntercom Auto Talk Answering Intercom CallsCall from Intercom 00-00-03 To transfer a call from the handset Transferring a CallCall Share ConferenceEx. a conference call with Handset 1 To join a conversation Call ShareStoring a Voice Mail Access Number Voice Mail ServicePress Ö Save key To erase a stored numberPress á at VM tone detect Setting the Voice Mail VM Tone DetectionListening to Voice Mail Messages Save directory HV.M. access Ringer settingTo listen to your voice mail messages After the voice mail box has received messagesFor Rotary or Pulse Service Users Special FeaturesTemporary Tone Dialing Muting Your ConversationHow to Use the Pause Button For Call Waiting Service UsersCall Waiting Caller ID Feature For PBX Line/Long Distance CallsSelecting the flash time Flash ButtonOr Ñ Press á Scroll to Set flash time by pressingIncoming Call Tone Ringer ToneWall Mounting To charge the handset battery Wall Mounting Adding Another PhoneBattery Replacement Canceling the Handset Registration Canceling Registration/Re-registrationPress á at Registration Re-registering the HandsetPress and hold Handset Locator #Press áIf the Following Appear Base unit. To cancel another handset When trying to store an item in the directory,Directory memory is full. To erase other items From the directory, seeProblem TroubleshootingYou cannot program items, Programming is not possible while Problem Cause & RemedyTo page. Try again later Recharge is displayed, Charge the battery fully pOr the base unit. Try again later Displayed and/or Continues to flash, orOnly Important Safety Instructions Useful Information FCC and Other Information For assistance, please call 1-800-211-PANA7262 FCC and Other Information Base unit SpecificationsIndex Auto Talk FeatureLimited Warranty Coverage Panasonic Telephone Products Limited WarrantyCustomer Services Directory When you ship the product For product serviceFor your future reference Serial No Date of purchase
Top Page Image Contents