2.8 Connecting Peripherals
the MOH Jack of the PBX.
Use an EIAJ
•Input impedance: 8 Ω
CAUTION
•Do not force audio cables into the jacks. Doing so may damage the connections and cause the audio to cut in and out.
•The MOH port is an SELV port and should only be connected to an approved SELV device, or in Australia, via the Line Isolation Unit with the Telecommunications Compliance Label.
Notes
•Use the supplied audio source connector in the event that the
•When the PBX and external audio source are not connected to the same earth, a humming noise may be heard in the BGM and MOH.
•The audio source used for BGM and MOH is determined by system programming.
•To adjust the sound level of the MOH, use the volume control on the external audio source.
Pager
Only 1 paging device
Use an EIAJ
•Output impedance: 600 Ω
CAUTION
The External Paging Jack is an SELV port and should only be connected to an approved SELV device, or in Australia, via the Line Isolation Unit with the Telecommunications Compliance Label.
Notes
•Use the supplied pager connector in the event that the
•To adjust the sound level of the pager, use the volume control on the loudspeaker or amplifier.
PC/Printer (via RS-232C)
A PC can be connected via the
Connect the PC or printer via an
Note
Use an
64