Panasonic KX-TG9541 Link to cell settings, Selecting which unit receives cellular calls

Link to Cell

Link to cell settings

Selecting which unit receives cellular calls

You can select which unit rings and receives calls for a cellular line. When “All” is selected, all handsets and the base unit ring.

Program this setting using either the base unit or one of the handsets.

Handset / Base unit

1For CELL 1: MMENUN#6271

For CELL 2: MMENUN#6272

For CELL 3: MMENUN#6273

For CELL 4: MMENUN#6274

2MbN: Select the desired handset or “All”. a

MSAVEN

3Proceed with the operation for your unit. Handset: MOFFN

Base unit: MEXITN

Note:

R When you select a specific handset to receive calls for a cellular line:

–other handsets cannot answer the calls.

–the base unit can answer the calls even though it does not ring. However, you can make the base unit ring by adjusting the base unit ringer volume (page 39).

R When you change the setting to “All”, the base unit ringer volume also returns to the lowest level even if the ringer volume has been changed.

R The units selected with this setting have the text message alert feature (page 51) applied to them.

Ring as cell mode

Once this feature is turned on, the handset and base unit ring using the same ringer tone as your cellular phone.

The following settings are available:

–“Off”: Turn this feature off to use the ringer tones of the handset and base unit. Caller information is announced depending on the Talking Caller ID setting (page 41).

–“On (with Talking CID)” (default): The handset and base unit use your cellular phone’s

ringer tone. Caller information is announced even if the Talking Caller ID is turned off.

–“On (without Talking CID)”: The

handset and base unit use your cellular phone’s ringer tone. Caller information is not announced even if the Talking Caller ID is turned on.

Program this setting using either the base unit or one of the handsets.

Important:

R To use this feature, your cellular phone must support Bluetooth in-band ringtone. Refer to your cellular phone’s operating instructions.

Handset / Base unit

1For CELL 1: MMENUN#6141

For CELL 2: MMENUN#6142

For CELL 3: MMENUN#6143

For CELL 4: MMENUN#6144

2MbN: Select the desired setting. a MSAVEN

3Proceed with the operation for your unit. Handset: MOFFN

Base unit: MEXITN

Note:

R The units use the preset ringer tones (page 40) instead of your cellular phone’s ringer tone when a cellular call is being received if your cellular phone is in silent mode (depending on your cellular phone).

R If your cellular phone is in silent mode with “On (with Talking CID)” set, the unit announces caller information even when Talking Caller ID is turned off (page 41).

To use the handset ringer tone instead of your cellular phone’s ringer tone

Select “Off” in step 2, “Ring as cell mode”, page 19.

To change the handset ringer tone for a cellular line, see page 39.

Auto connection to the cellular phone

After pairing, your cellular phone is connected to the base unit. If you move the cellular phone out of base unit range, the cellular phone is disconnected from the base unit. This feature allows the base unit to try to reconnect the cellular phone at regular intervals when it returns within base unit range. You can set the interval. The default setting is “1 min”.

For assistance, please visit http://www.panasonic.com/help 19

TG954x(en)_0628_ver031.pdf 19

2013/06/28 12:35:30