Panasonic KX-TG2670N Digits long, the number will not be, Redialed correctly

ProblemRemedy

The unit does not display the caller’s name and/or phone number.

•You need subscribe to a Caller ID service from telephone companies.

•Other telephone equipment may be interfering with your phone. Disconnect it and try again.

•Other electrical appliances connected to the same outlet may be interfering with the Caller ID information.

•Telephone line noise may be affecting the Caller ID information.

The handset or the base unit •Do not pause for over 60 seconds while

display goes to the standby	•	searching.
mode while viewing the		,	or (DIGITAL!SP-PHONE).
Caller List.		was pressed.
When a second call is	•The line mode selection is incorrect. See
received during a		page 14.
conversation, the unit does
not display the new caller’s
name and/or phone number.
You cannot page the	•The handset is too far from the base unit.
handset or the base unit.	•The handset or the base unit is engaged
		in an outside call or is viewing the Caller
		List/directory list. Try again later. If you
		are using the base unit, wait until
		“Handset in use” disappears.
You cannot redial by	•If the last number dialed was more than
pressing (REDIAL/PAUSE) or		32 digits long, the number will not be
(REDIAL).		redialed correctly.

•Access numbers entered after pressing (TONE) will not be included when redialing.

•The (REDIAL/PAUSE) button on the handset has a double function as either redial or pause. It will redial the last number dialed if pressed at the outset of a call (p. 27). If another number has been dialed first, it will operate as a pause button (p. 52).

Useful Information

83