| Useful Information |
|
|
|
|
Troubleshooting |
|
|
|
General use |
|
|
|
Problem | Cause & solution |
The unit does not work. | L Make sure that the battery is installed correctly (page |
| 11). |
| L Check the connections (page 10). |
| L Fully charge the battery (page 12). |
| L Clean the charge contacts and charge again (page 12). |
| L Unplug the base unit’s AC adaptor to reset the unit. |
| Reconnect the adaptor and try again. |
| L |
|
|
The display shows “No | L The handset is too far from the base unit. Move closer |
link to base. Move | and try again. |
closer to base, try | L Plug in the base unit’s AC adaptor. |
again.” and an alarm | L Raise the base unit antennas. |
tone sounds. | L If the above remedies do not solve the problem, the |
| handset may have lost communication with the base |
| unit. Register the handset again (page 38). |
|
|
I cannot hear a dial tone. | L Confirm that the telephone line cord is connected (page |
| 10). |
| L Disconnect the unit from the telephone line and connect |
| a known working telephone. If the working telephone |
| operates properly, contact our service personnel to |
| have the unit repaired. If the working telephone does |
| not operate properly, contact your telephone company. |
|
|
|
|
Programmable settings | |
|
|
Problem | Cause & solution |
I cannot programme | L Programming is not possible while the handset and |
items. | base unit are being used. |
| L Do not pause for over 1 minute while programming. |
| L Move closer to the base unit. |
| L While another user is listening to messages or the |
| answering system is answering a call, you cannot |
| programme. Try again later. |
|
|
While programming, the | L A call is being received. Answer the call and start again |
handset starts to ring. | from the beginning after hanging up. |
57