D-Link DVG-2101S user manual SIP Setting

Page 25

Advanced

DVG-2101S User Manual

SIP Setting

This page allows you to configure the settings related to the SIP service provider. You need to configure your VoIP Adapter to communicate with the devices that will send and receive telephone calls over the Internet.

If you are behind a NAT modem or router, you may have to use a STUN server.

Signaling	Enter the signaling port to send and receive the SIP message
Port	for building a session. The default value is 5060 and this must
	match with the peer Registrar when making VoIP calls.
RTP Start	Specifies the start port for the RTP stream. The default value is
	40000.
RTP End	Specifies the end port for the RTP stream. The default value is
	50000.
STUN	Enable or disable the STUN server feature.
Server	Enter the STUN server IP address if you enabled the STUN
Address	server feature.
NAT Keep	Check the checkbox and enter the time period for the NAT to
Alive Time	keep alive.
Rport	Check this checkbox to use rport. Rport, or symmetric
	signaling, is critical for operations behind some classifications
	of NATs. If enabled, the SIP stack will send outbound SIP
	messages on the same port that it listens on. Unless you are
	familiar with single SIP port, it is better to use rport.
T.38 Fax	Check the checkbox if the remote end also supports FAX
Protocol	function.

23

Image 25

Contents DVG-2101S VoIP Telephone Adapter Table of Contents Introduction Package Contents„ NTP Features„ VPN Front Panel Power LEDPhone LED Register LEDRear Panel Reset ButtonConnecting the DVG-2101S Directly to a Modem Hardware InstallationConnecting the DVG-2101S Behind a Router Hardware Installation Enter or Return key ConfigurationStep Click Setup WizardStatic IP users have to set the DNS address Click Next Step Internet Setup SetupConnection Type Dynamic IPStatic IP Service Name PasswordName PPPoEClone MAC Address CloneStatic Routing SIP Account List VoIP SetupNumber Phone BookTime and Date Internet Time Zone Enable Daylight Saving DatesCall Feature VoIP SettingsAdvanced Scenario Examples of Making a Conference CallSIP Setting Digit Plan Component Description Digit Plan Syntex To specify a Enter the following ResultIVR Digits InputScenario Rule Combination VoIP Adapter will do… Digit MapMode PrefixMin Len ExampleDial Prefix Priority CodecCodec PacketizationPhone Setting DNS Dynamic DNS Timeout StatusServer Address Host Name Username or Key QoS VPN Dialing out SettingsLAN Mask Configuration MaintenanceSystem Times Period File Auto ProvisionSnmp for Snmp model only Log Setting Firmware Update Admin Current Password Admin New Access ControlPing Test Device Information StatusVoIP Status CDR Status VPN Status Network Status System Log Help Menu HelpConfiguration through IVR Why can’t I access the web-based configuration utility? Frequently Asked QuestionsHow can I check if my IP address is correct for logging in? What can I do if I forgot my password?Can I use my DVG-2101S on a Mgcp network? How can I set my computer to use a static IP address?Technical Specifications FCC Caution FCC EMI Statement