EFJohnson High Tier, LTR 98xx manual Placing Telephone Calls

TELEPHONE CALLS

TELEPHONE CALLS

Placing Telephone Calls

NOTE: Telephone calls can be placed and received only if that service is available to you and your transceiver has been programmed appropri- ately. A microphone equipped with a telephone keypad is required to dial the telephone number.

The telephone calling feature allows you to place and receive tele- phone calls using your transceiver. The following information describes how these calls are made with LTR operation. If you can make telephone calls with conventional operation, the procedure may be somewhat different and your system operator will then provide additional informa- tion. Proceed as follows:

1.Turn transceiver power on and set the volume as described starting on page 15.

2.Select the system and group programmed for telephone calls. When a

telephone group is selected, is displayed.

3.To obtain the dial tone, briefly press the PTT switch. If the proceed tone is used, press the PTT switch until a beep sounds. If a dial tone is then heard, proceed to step 4.

Busy and Out-Of-Range Conditions

Busy and out-of-range conditions are indicated the same as with LTR standard calls described on page 19. The following additional features may be available with telephone calls:

Busy - If Busy Queuing is programmed (see page 42), the call is auto- matically placed in a queue when the PTT switch is released. The Busy Queuing mode is indicated by “IN QUEUE” in the display.

21