EFJohnson High Tier FCC Exposure Limits, Limits For General Population/Uncontrolled Exposure

Page 5

SAFETY INFORMATION

FCC EXPOSURE LIMITS

This mobile radio transceiver was tested by the manufacturer with an appropriate antenna in order to verify compliance with Maximum Per- missible Exposure (MPE) limits set under Section 2.1091 of the FCC Rules and Regulations. The guidelines used in the evaluation are derived from Table 1 (B) titled “Limits For General Population/Uncontrolled Exposure” which is from FCC report OET bulletin #65.

Table 1

FCC Limits for Maximum Permissible Exposure (MPE)

(A) Limits For Occupational/Controlled Exposure

Frequency Range

Electric Field

Magnetic Field

Power Density

Averaging

(MHz)

Strength (E)

Strength (H)

(S)

Time E2, H2,

(V/m)

(A/m)

(mW/cm22)

S (minutes)

 

0.3-3.0

614

1.63

(100)*

6

3.0-30

1842/f

4.89/f

(900/f2)*

6

30-300

61.4

0.163

1.0

6

300-1500

--

--

f/300

6

1500-100,000

--

--

5

6

 

 

 

 

 

(B) Limits For General Population/Uncontrolled Exposure

Frequency Range

Electric Field

Magnetic Field

Power Density

Averaging

(MHz)

Strength (E)

Strength (H)

(S)

Time E2, H2,

(V/m)

(A/m)

(mW/cm22)

S (minutes)

 

0.3-1.34

614

1.63

(100)*

30

1.34-30

824/f

2.19/f

(180/f2)*

30

30-300

27.5

0.073

0.2

30

300-1500

--

--

f/1500

30

1500-100,000

--

--

1.0

30

 

 

 

 

 

f = Frequency in

MHz

*Plane-wave

equivalent power

density

Table 2 lists the antenna whips and bases recommended for use in each frequency range. Each model of this radio was tested with the appro- priate antenna listed. The antenna was mounted in the center of the roof

5

Image 5
Contents High Tier Operating Manual Page Page Safety Information Limits For General Population/Uncontrolled Exposure FCC Exposure LimitsFrequency Whip Model No Base Model No Table of Contents Table of Contents Quick Reference Guide General Features FeaturesFront Panel Controls Controls and DisplayMicrophone Push-To-Talk PTT Switch Not Shown Push-button on Rear Panel Jacks and Connectors Display Description General Operation Power-Up SequenceDetermining Volume Level Alpha Tag Display Mode Numeric Display ModeBacklight Operation System/Group Display InformationSelecting the System and Group Select Mode Indication With Numeric DisplaySelect Mode Indication With Alpha Tag Display Setting Squelch Control Introduction Standard CallsPlacing a Standard Call LTR OperationReceiving a Standard Call Conventional OperationPlacing Telephone Calls Telephone CallsReceiving a Telephone Call Bank Select General FeaturesLandside-Originate Calls Encryption Call IndicatorEmergency Switch Function FCN Switch Encryption IndicatorHorn Alert Home System/Group SelectOption Select Power Turn-Off DelayProceed Clear-To-Talk Tone Receive-Only Groups Stealth ModeTime-Out Timer Option Switches Option Switches and Menu ModeTone Select Transmitter Thermal FoldbackSwitch Menu Mode and Option Switch FunctionsUsing Menu Mode Menu Mode IntroductionSystem and Group Scan System and Group Scan Scan List Programming Transmitting In The Scan Mode Scan Delay and Continue TimersSystem and Group Scan General LTR and Conventional ModesMonitoring Conventional Channels Before Transmitting Calls on Priority and Block ID Codes LTR FeaturesStandard and Telephone Calls Transmit Inhibit System Search Busy QueuingTranspond Transmit Disable On Busy Conventional FeaturesMonitor Mode Talk-Around Priority Group Sampling Call Guard SquelchSupervisory Tones MiscellaneousMiscellaneous LTR Telephone Call Tones Display Messages Miscellaneous Bright DIM OFF Menu Mode MessagesSpeaking Into Microphone System Operator ProgrammingLicensing Preventing Battery DischargeOperation At Extended Range Transceiver Service