EFJohnson LTR 98xx, High Tier manual Receiving a Telephone Call

Page 22

TELEPHONE CALLS

Out-of-Range - If the System Search feature is selected (see page 42), that feature is automatically selected when the PTT switch is released. The System Search mode is indicated by “SYS SRCH” in the display.

4.With the dial tone sounding, dial the number using the 0-9 keys on the microphone keypad. If the microphone has a memory, you may also be able to recall the number from memory. The PTT switch does not need to be pressed while you are dialing if the transmitter automatically keys. If too much time elapses between digits, the call is terminated.

5.After the number is dialed, release the PTT switch (if it was pressed). Landside ringing (or a landside busy condition) should then be heard.

6.When the other party answers, press the PTT switch and respond. The PTT switch must be pressed to talk and released to listen (the same as with mobile-to-mobile calls).

7.When the call is finished, it should be terminated. This is usually done by pressing the # key, and termination is indicated by three beeps. Terminating the call in this manner prevents extra billing that may occur while the system automatically detects the end of the call.

Receiving a Telephone Call

1.Turn transceiver power on and set the volume as described starting on page 15.

2.Select or scan the system and group programmed for telephone calls.

When a telephone group is selected, is displayed.

3.When “ringing” is heard, press the PTT switch and respond. The PTT switch must be pressed to talk and released to listen the same as with standard calls.

4.When the call is finished, it should be terminated as in step 7 of the preceding section.

22

Image 22

Contents High Tier Operating Manual Page Page Safety Information FCC Exposure Limits Limits For General Population/Uncontrolled ExposureFrequency Whip Model No Base Model No Table of Contents Table of Contents Quick Reference Guide Features General FeaturesControls and Display Front Panel ControlsMicrophone Push-To-Talk PTT Switch Not Shown Push-button on Rear Panel Jacks and Connectors Display Description Determining Volume Level Power-Up SequenceGeneral Operation Backlight Operation Numeric Display ModeAlpha Tag Display Mode System/Group Display InformationSelect Mode Indication With Alpha Tag Display Select Mode Indication With Numeric DisplaySelecting the System and Group Setting Squelch Control Placing a Standard Call Standard CallsIntroduction LTR OperationConventional Operation Receiving a Standard CallTelephone Calls Placing Telephone CallsReceiving a Telephone Call Landside-Originate Calls General FeaturesBank Select Emergency Switch Call IndicatorEncryption Encryption Indicator Function FCN SwitchHome System/Group Select Horn AlertPower Turn-Off Delay Option SelectProceed Clear-To-Talk Tone Time-Out Timer Stealth ModeReceive-Only Groups Tone Select Option Switches and Menu ModeOption Switches Transmitter Thermal FoldbackMenu Mode and Option Switch Functions SwitchMenu Mode Introduction Using Menu ModeSystem and Group Scan System and Group Scan Scan List Programming Scan Delay and Continue Timers Transmitting In The Scan ModeSystem and Group Scan LTR and Conventional Modes GeneralMonitoring Conventional Channels Before Transmitting Standard and Telephone Calls LTR FeaturesCalls on Priority and Block ID Codes Transmit Inhibit Busy Queuing System SearchTranspond Monitor Mode Conventional FeaturesTransmit Disable On Busy Talk-Around Call Guard Squelch Priority Group SamplingMiscellaneous Supervisory TonesMiscellaneous LTR Telephone Call Tones Display Messages Miscellaneous Menu Mode Messages Bright DIM OFFSystem Operator Programming Speaking Into MicrophoneOperation At Extended Range Preventing Battery DischargeLicensing Transceiver Service