Kenwood VC-H1 Auxiliary Functions, Memory Protection, Memory Reset, Battery Saver

AUXILIARY FUNCTIONS

MEMORY PROTECTION

You can protect the captured or received images from being accidentally erased.

1 Slide the PWR switch upward to turn the power ON.

• The TX/RX indicator lights green.

2Press [MR] to recall the desired image.

•Each press of [MR] increments the channel number.

•If no operation is performed for

approximately 30 seconds with Battery Saver ON, the monitor is deactivated; the default is ON.

3Press [HOLD] to switch Protection ON (or OFF).

• When the channel is protected, its number on the monitor turns red.

Note: When the protected memory channel is currently selected, the VC-H1 may still capture or receive an image to display on the monitor. However, the protected channel will not be used to store the newly displayed image.

MEMORY RESET

You may sometimes want to reset all settings back to the factory defaults and clear the memory channels.

Press [S]+[HOLD]+ POWER ON.

BATTERY SAVER

If no operation is performed for approximately 30 seconds, Battery Saver automatically turns OFF the power to the camera and monitor units. Pressing [S] activates the units again.

To switch Battery Saver ON (default) or OFF, press [MR]+ POWER ON.

•“SAVE-ON” or “SAVE-OFF” appears to indicate the new status.

•The TX/RX indicator lights green when Battery Saver deactivates the camera and monitor.

•The VC-H1 can still receive images when Battery Saver is ON.