Capturing Images

The VC-H1 has 10 memory channels to store captured images.

1Slide the PWR switch upward to turn the power ON.

•The TX/RX indicator lights green.

2Press [S] to activate both the camera and LCD monitor.

•The TX/RX indicator goes out.

3While looking at the LCD monitor, turn and focus the camera onto an object.

4Press [S] again to capture the image.

•When capturing is completed, the camera is deactivated and the TX/RX indicator lights green again.

5Press [MR] to store the captured image in a memory channel.

•You may skip this step if you do not store the image.

6Repeat step 2 to 5 to capture and store a maximum of 10 desired images.

•When all channels are full, the currently selected channel is overwritten with a newly captured image.

7To confirm the stored images, press [MR].

•The currently selected channel number appears at the top right of the monitor.

•Each press of [MR] increments the channel number.

Note:

◆While capturing images, the VC-H1 does not receive images sent from other parties.

◆If no operation is performed for approximately

30 seconds with Battery Saver ON {page 11}, the camera and monitor are deactivated; the default is ON.

◆Pressing [S] again immediately after activating the camera and monitor may cause the captured image to be distorted; the camera is not yet ready for image capture.

◆The VC-H1 does not allow you to specify an individual image to be erased. To erase unnecessary images, use one of the following methods:

•Perform Memory Reset to erase all images at one time {page 11}.

•When all channels are full, recall the unnecessary image, capture a new image, then press [MR].